Enlaces rápidos

Surge Protector
Instructions
NOTE: This surge protector must be plugged into the top outlet of the wall
receptacle to ensure the center mounting screw of the surge protector is
installed properly.
Permanent Installation:
1. Disconnect power to the receptacle at the service panel.
2. Remove the center screw from the existing wallplate. The wall plate will be
secured by the mounting screw included with the surge protector.
3. Remove the mounting screw hole cover on the surge protector with a small
flat blade screwdriver.
4. Plug surge protector into the top receptacle of the wall outlet, over the
wallplate, to ensure coverage of the unused receptacle and secure with
the center mounting screw provided. Replace the screw hole cover.
5. Restore power at the service panel.
6. Make sure electronic equipment is turned off before plugging into the
surge protector outlets. Do not use extension cords to connect equipment
to the surge protector.
7. Connected equipment can now be turned on.
NOTE: In the event that the protection capacity is exceeded by a power surge
or the protection components expire, the power will be permanently shut down
to the outlets, ensuring surge protection for your electronic equipment. At this
time, the surge protector has reached end of life and must be replaced.
A glowing blue "Grounded" indicator light shows that your surge protector is
plugged into a grounded receptacle and that your surge protector's ground
protection components are providing protection from ground surges. If the
"Grounded" indicator light stops glowing, it is possible that the surge protector's
ground protection components have expired or that the wall receptacle is no
longer grounded.
Surge Protector — Limited-Lifetime Warranty
Jasco Products Company warrants this surge protector to be free of defects
in workmanship and/or materials for the life* of the surge protector. If such
a defect should arise during the life of the surge protector, Jasco Products
Company will, at its option, either repair or replace the surge protector
without charge. This warranty does not cover damage caused by lightning,
accident, misuse or alterations to the surge protector.
* This surge protector, like all surge protectors, has a finite lifespan. Even
under normal circumstances and in the absence of defects, the product's
life will expire when the surge protector's component capacity has been
exceeded, thereby ceasing to provide protection from surges. In this event,
the Limited-Lifetime Warranty is no longer valid and the surge protector
should be replaced.
Warranty replacement procedure
1. Call Jasco Products Company Customer Information Center at
1-800-654-8483 to get a Return Authorization Number (RA#), shipping
instructions and a prepaid return address label.
2. After you have received the prepaid return address label, return the Jasco
Products Company surge protector, freight prepaid, to Jasco Products
Company. Surge protectors returned to Jasco Products Company must
have an RA# included in the mailing address to be accepted.
3. The original purchaser will be asked to send the surge protector, a copy of
the sales receipt for the product, your name, address, phone number and
a description of the problem.
Connected Equipment Warranty
Equipment Replacement Guarantee for Surge Model: 37063
Maximum Warranty Amount: $50,000 (USD)
NOTE: This device is not a lightning arrestor, so it will not afford protection
when lightning strikes nearby power line, the house, service entrance
or antenna. The Warranty is void if a power disturbance damages your
equipment through the coax, phone or network lines.
Jasco Products Company will pay up to the maximum warranty amount
offered for the surge protector purchased to repair or replace up to an
amount equal to the fair market value or the original purchase price,
whichever is less, of your electronics equipment, if damaged by a transient
surge (except those caused by direct lightning), within the life* of the surge
protector, while properly and directly connected to this surge protector.
JASCO PRODUCTS COMPANY DISCLAIMS AND ASSUMES NO LIABILITY FOR
ANY OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT
NOT LIMITED TO, LOSS OR DAMAGE TO SOFTWARE OR DATA OR DAMAGES OR
COSTS ASSOCIATED WITH BUSINESS INTERRUPTION OR OTHER DAMAGES DUE
TO LOSS OR DAMAGE TO EQUIPMENT, SOFTWARE OR DATA. Some states do
not allow the exclusion or limitation of incidental or consequential damages,
so the above limitation or exclusion may not apply to you. This warranty
gives you specific legal rights, and you may also have other rights that may
vary from state to state.
This warranty is secondary to any existing coverage of any connected
equipment, including but not limited to, any manufacturer's warranty,
extended warranties or insurance coverage.
To qualify for a connected equipment warranty:
1. All connected equipment must be UL and/or CSA approved.
2. The Jasco Products Company surge protector must be plugged into
properly wired and grounded outlets, no extension cords, adapters, other
ground wires or electrical connectors may be used, with the sole exception
of other standard Jasco Products Company 120 volt products approved
for that use. The installation must comply with all applicable electrical and
safety codes set forth pursuant to the National Electrical Code (NEC).
3. Any claim under the warranty policy must be made within 15 days of the
date of the alleged damage to the connected equipment.
For connected equipment coverage, the following conditions must
be satisfied:
A) All equipment eligible for warranty coverage must be plugged directly
into the Jasco Products Company surge protector. Equipment connected
to the protected equipment, but not plugged directly into the surge
protector will not be covered.
B) The equipment must have been damaged by a covered power disturbance
that passed through the Jasco Products Company surge protector.
C) The Jasco Products Company surge protector must be damaged from the
power disturbance.
D) The Jasco Products Company surge protector's protection capacity must
not have been exceeded.
Connected equipment claim procedure:
1. Call Jasco Products Company Customer Information Center at 1-800-654-8483
to get a Return Authorization Number (RA#), shipping instructions and a
prepaid return address label.
2. After you have received the prepaid return address label, return the Jasco
Products Company surge protector, freight prepaid, to Jasco Products
Company. Surge protectors returned to Jasco Products Company, Inc.
must have an RA# included in the mailing address to be accepted.
3. Jasco Products Company will determine whether the damage to your
equipment is covered by this warranty policy. If you are covered, a claims
adjuster will contact you and Jasco Products Company will do one of the
following at its own discretion:
a) Authorize a service center to repair damaged equipment.
b) Replace damaged equipment with equivalent or better.
c) Reimburse customer the fair market value of the damaged equipment.
CAUTION
TO REDUCE THE RISK OF ELECTRIC
SHOCK - DISCONNECT POWER
TO THE RECEPTACLE BEFORE
INSTALLING OR REMOVING THE
UNIT. WHEN REMOVING THE COVER
SCREW, COVER MAY FALL ACROSS
PLUG PINS OR RECEPTACLE MAY
BECOME DISLODGED. DO NOT USE
THIS DEVICE WITH A RECEPTACLE
IN WHICH THE SLOT OPENINGS DO
NOT ALIGN WITH THE BLADES. NOT
FOR USE WITH RECEPTACLES THAT
CONTAIN GROUND-FAULT CIRCUIT
.
INTERRUPTERS, INDICATOR LIGHTS,
OR CONTROLS. USE ONLY WITH
DUPLEX RECEPTACLE HAVING CENTER
SCREW. SECURE UNIT IN PLACE WITH
SCREW PROVIDED.
WARNING
RISK OF ELECTRIC SHOCK
• DO NOT USE IN WET LOCATIONS
• KEEP CHILDREN AWAY
• USE INDOORS ONLY
• FULLY INSERT PLUG
• DO NOT USE WITH METAL WALL
PLATES
RISK OF FIRE
• DO NOT EXCEED ELECTRICAL
RATINGS
NOT FOR USE WITH
• AQUARIUMS OR OTHER WATER-
RELATED PRODUCTS
• GENERATORS AND POWER INVERTERS
.
• MEDICAL LIFE-SUPPORT PRODUCTS
MADE IN CHINA
GE is a trademark of General Electric Company and is
under license by Jasco Products Company LLC, 10 E.
Memorial Rd., Oklahoma City, OK 73114.
This Jasco product comes with a limited-lifetime
warranty. Visit www.byjasco.com for warranty details.
Questions? Contact us at 1-800-654-8483
between 7:00AM—8:00PM CST.
37063 V3
6/03/17
loading

Resumen de contenidos para GE 37063

  • Página 1 1. Call Jasco Products Company Customer Information Center at C) The Jasco Products Company surge protector must be damaged from the GE is a trademark of General Electric Company and is 1-800-654-8483 to get a Return Authorization Number (RA#), shipping power disturbance.
  • Página 2 Jasco Products Company. A fin de que se reciban y acepten Garantía de equipos conectados los supresores de sobretensiones devueltos a Jasco Products Company, Inc. Garantía de reposición de aparatos para el modelo de supresor: 37063 estos deben incluir el número RA en la dirección postal. de sobretensiones Importe máximo de la garantía: USD 50,000...