Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Connect the tubing from
the UV clarifier to the small
adapter.
Step 6. Turn over the filter
cover and locate the groove
along the outside edge of
the raise surface. Inspect the
o-ring to find the flat edge.
One side will have a curve and the other
side will be flat. Insert the flat side of the
o-ring down as you place into the groove.
Step 7. Turn the cover with the o-ring
back over and place in the opening in the
filter.
Step 8. Screw the lid onto the top of the
tank. Make sure the lid is secure or the
filter will leak.
Step 9. Connect the UV Clarifier into a
properly grounded electrical outlet.
Step 10. Wait several seconds then
check the indicator light to verify if the UV
bulb is functioning properly.
NOTE: This UV clarifier includes a safety
feature that will not allow the light to turn
on if the lamp holder or locking ring are
not securely fastened.
Step 11. Unplug your pump from an
electrical source before connecting
tubing. Connect tubing from the outlet
of the pump to the inlet of the filter
(upper hole). Return water to the pond
by connecting tubing to the outlet of
the filter and to the inlet of a water
feature or return to the pond. You
can reconnect your pump into a
properly grounded electrical outlet at
this time.
Note: Pump and tubing are not
included.
6
7
8
9
GFCI
outlet
10
11
5
Tabla de contenido
