LUND 34641349 Instrucciones De Instalación

Installation I nstructions
I-­‐Sheet N umber T HX13
Parts I ncluded: Q ty
Driver s ide s tep 1
Passenger s ide s tep 1
Hardware P ack 1
M8 x 3 5mm H ex h ead b olt 1 2
M8 F ender w asher 1 2
M8 l ock w asher 1 2
3/8" s peed c lips 1 0
3/8" x 1 " H ex b olt 1 0
3/8" F lat w asher 2
INSTRUCTIONS:
S tep 1: Locate the driver's side Nerf Step. The driver side will have the shorter front bracket.
Step 2: Beginning with the driver's side; locate the six sets of 8mm threaded mounting holes. (3
on each side of the vehicle). These are positioned on the vertical sides of the floor pan beneath
the doors, with one set of holes each in the front, middle, and rear of the vehicle cab.
Step 3: Next, align the Nerf-step brackets with the factory mounting positions and install the
supplied M8x35mm hex bolts, nuts, flat washer and lock washer. Loosely fasten at this time.
Step 4: Starting with the rear bracket, push upward on the step as far as it will go and fully
tighten one of the M8 hex bolts. Next, move to the front bracket and push upwards on the step as
far as it will go and fully tighten both M8 Hex bolts. Finish by fully tightening the center bracket
and the second bolt on the rear bracket.
Step 5: NOTE: Some models require additional clips and bolts. If your model has threaded
mounts, skip step 6.
4325 H amilton M ill R d. S te. 4 00 | B uford, G A 3 0518 | 8 00.241.7219 | l undinternational.com
PART N UMBER:
N erf S teps
PRODUCT:
: 1 5-­‐16 R am 1 500
APPLICATION
3 4641349,
3 4641388