Unpacking; Before First Use; Installation; P Lace Of Installation - Listo CAL170-60B1 Manual De Utilización

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

UNPACKING

Check that the appliance has not been damaged during transportation. Do
not plug in a damaged appliance under any circumstances! If the appliance is
damaged, please contact your retailer.

BEFORE FIRST USE

Clean the inside of the appliance and any accessories provided with lukewarm
water with a little white wine vinegar added to it. Do not use soap or detergent
as the odour may persist. After cleaning, dry the appliance completely.
To clean the appliance, always turn it off and unplug it, or remove the fuses or
turn off the circuit breaker.

INSTALLATION

p
lACe of instAllAtion
Place your freezer on a stable, level surface. Your appliance will be heavy when
loaded with food: it must therefore be placed on a solid and resistant floor.
The appliance must be installed in a dry, well-ventilated room at room temperature
(16°C minimum and 38°C maximum). Leave a space of at least 10 cm around the
appliance. Screw the spacers into the back of the device to make sure that there
is enough clearance.
Never place an appliance that emits heat (microwaves, toasters, etc.) on the
freezer.
The appliance must not be exposed to direct sunlight.
The appliance must not be exposed to rain.
The appliance must not be installed next to a radiator, stove or any other heat
source.
The appliance's energy consumption and efficient operation are affected by the
room temperature.
The installation of the appliance must not obstruct the outlet.
After installation, make sure that it is not resting on its power cord.
Leave the appliance in its final location for two hours before plugging it in.
This will allow the refrigerant circuit to stabilise.
C
limAte ClAsses
Only install the appliance in a location where the room temperature matches the
climate class for which it was designed (see table below).
V.1.0
38
The climate class is on the rating plate located on the outside of the appliance. The
table below shows the correct room temperature for each climate class:
Climate classes
SN
N
ST
T
Your CAL170-60b1 freezer is "N/ST" rated. If the room temperature is below or above
the rated room temperature, the performance of your freezer may be affected, and
your food may spoil.
s
uffiCient ventilAtion
Make sure that air can always circulate freely around the appliance.
For the appliance to run properly, do not obstruct the vents and leave a space of
at least 20 cm above the device, 10 cm between the back and the wall and 2 cm
on each side.
If your appliance has to be installed next to a refrigerator or another freezer,
make sure the appliances are not touching each other to prevent condensation
from forming on the outside.
l
evelling
For vibration-free operation, the appliance needs
to be in a level position. To do this, adjust the
adjustable feet at the front to properly level the
appliance.
r
eversing the opening direCtion of the door
You can change the opening direction of the door of your freezer, if necessary. To
make this change, follow the steps below or contact a qualified professional.
Unplug the appliance from the electrical outlet when reversing the opening
direction of the door.
Room temperature
+10 to +32°C
+16 to +32°C
+16 to +38°C
+16 to +43°C
39
V.1.0
Tabla de contenido
loading

Tabla de contenido