Idiomas disponibles
Idiomas disponibles
C
B
Wallmount Instructions
The UPSWM is shipped in its collapsible position and includes two mounting braces. Open the
mounting bracket, hold the bracket level against the intended mounting surface and mark the
locations of the mounting holes
washers around the included screws, then drive the screws through the mounting holes and into the
guide holes. Install the mounting braces by putting the two buttons
holes on the side of the unit
CAUTION: The hardware (screws and washers) included with the bracket is only intended for
use with plywood surfaces. To mount your bracket on a different surface, you must determine
a safe mounting procedure and obtain proper hardware.
Mounting a UPS System or Battery Pack
CAUTION: Before mounting a UPS, make sure the UPS is OFF and unplugged. Before mounting
a BP36V27 battery pack, make sure the battery pack is disconnected from your UPS system.
The UPS or battery pack is extremely heavy. Take care to avoid injury while lifting.
Place the UPS or battery pack in the mounting tray. The feet of a UPS should press against the rear
ridge
and fit around the center ridge
D
The base of a battery pack should fit between the rear
wall.
Next, pass the safety strap around the UPS or battery pack and through the mounting tray as shown.
The safety strap should pass through the tray's outer strap holes for a UPS or through the tray's inner
strap holes for a battery pack. Fully tighten the safety strap and fasten the hook-and-loop end.
Visit www.tripplite.com/warranty today to register your new Tripp Lite product. You'll be automatically entered into a
drawing for a chance to win a FREE Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.
Use of this equipment in life support applications where failure of this equipment can reasonably be expected
to cause the failure of the life support equipment or to significantly affect its safety or effectiveness is not
recommended.
Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice.
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
17-02-281-932696.indd 2
A
C
B
A
C
D
E
C
. Drill 1/8" guide holes in these locations. Place the included
A
.
C
while the front of the UPS presses against the front ridge
E
F
on each brace through the
B
and center
ridges, with its cords facing the
D
E
2
.
F
3/8/2017 8:58:14 AM
