Idiomas disponibles
Idiomas disponibles
English
CONTENTS / DESCRIPTION
Monaë Light
pelvic belt:
®
- 1 elastic band,
- 2 silicone pads.
Product leaflet to read carefully.
INDICATIONS
During pregnancy:
Relieves lower back pain, pubic
symphysis pain (pubalgia), pelvic and/or
sacroiliac pain. Protects the perineum.
Prevents and relieves sciatica pain.
After the birth:
Relieves pubic symphysis pain.
Supports the pelvic floor. Enables
an additional action during perineal
reeducation sessions.
(Can be used during daily activities and/
or when standing for long periods).
COMPOSITION
Elastic band:
77% polyamide, 23% elastomer.
Fastening straps:
76% polyamide, 24% elastomer.
Velvet:
72% polyamide, 28% polyurethane.
Pads: Silicone.
Velcro: Polypropylene.
SAFETY INSTRUCTIONS
This product must be fitted by a health
professional (pharmacist, orthopaedist,
physiotherapist, etc.). If rash, irritation
or swelling remove the product and
consult a doctor or prosthetist. Protect
any part of the body to which an
analgesic may have been applied
before fitting the product. It is not
recommended for other patients to
reuse this product. In the event of a
serious incident with the device, inform
the manufacturer and the competent
authority.
WASHING INSTRUCTIONS
- Wash by hand with neutral soap
(max. 30 °C),
- Rinse carefully,
- Allow to dry in the open air,
- Do not dry in a dryer,
- Do not use bleach,
- Do not hang up or iron and do not
expose to direct heat sources such as
stoves, heaters, radiators, direct sun
light etc. During use or during washing
do not use alcohols, ointments or
dissolvent liquids. If the orthesis is not
properly dried any detergent residues
could irritate the skin and deteriorate
the product.
t o d m U
Store at room temperature.
In order to dispose of the packaging
and the product, strictly comply with the
legal norms of your community.
FITTING
POSITIONING POINT:
A
Figure 1
- Fit while standing up with your legs
slightly apart in line with your hips.
- Move one of your legs away slightly to
one side (Fig. 1).
- Locate the hollow between the upper
part of the leg and the hip.
This will be the product positioning
point.
FITTING:
B
Figures 2 and 3
- Place the band in line with the
positioning point.
- Check that the pads are centred
(Fig. 2).
- Adjust if necessary (Fig. 3).
C
Figure 4
- Fasten the band with the velcro
(Fig. 4).
- Adjust the tightness if necessary.
D
Figure 5
- Then fasten the two posture
reinforcement side straps to the
desired tightness (Fig. 5).
- Check the alignment and positioning
(Fig. 6).
NOTE:
The fastening straps may overlap.
®
