Midea MAD20S1QWT Manual Del Usuario página 4

WARNING
• Avoid fire hazard or electric shock.
Do not use an extension cord or an adaptor plug. Do not remove any prongs
from the power cord.
• Plug in power plug properly.
Otherwise, it may cause electric shock or fire due to excess heat generation.
• Always ensure effective grounding.
Incorrect grounding may cause electric shock.
• Unplug the unit if strange sounds, smells, or smoke come from it.
A damaged product may cause fire and electric shock.
• Ventilate room before operating the unit if there is a gas leak from other appliances.
• If the power cord is damaged, it must be replaced by the manufacturer or an
authorized service center in order to avoid electrical risk.
• Before cleaning, turn off the power and unplug the unit.
• Be sure the dehumidifier has been securely and correctly installed according to
the installation instructions in this manual. Save this manual for possible future
use in removing or installing this unit.
• Be sure the dehumidifier is properly grounded. To minimize shock and fire
hazards, proper grounding is important.
The power cord is equipped with a three-prong grounding plug for protection
against shock hazards.
• Your dehumidifier must be used in a properly grounded wall receptacle. If the
wall receptacle you intend to use is not adequately grounded or protected by a
time delay fuse or circuit breaker, have a qualified electrician install the proper
receptacle. Ensure the receptacle is accessible after the unit installation.
• Be sure the electrical service is adequate for the model you have chosen. This
information can be found on the serial plate, which is located on the side of the
cabinet and behind the grille.
• Make sure the bucket is empty of water before nesting unit.
It could cause electric shock and/or damage the unit.
• Unplug the unit before nesting it in the bucket.
It could cause electric shock and/or damage the unit.
• When unplugging the unit, be sure to grab the plug, not the cord.
 Page 4 