Simer OD660IG Manual Del Usuario página 3

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
GB
6. Wear safety glasses when working on the
pump.
7. Keep work area clean, uncluttered, and
properly lighted.
8. Keep visitors at a safe distance from the
work area.
9. Make the workshop child-proof.
NOTICE: This unit is not designed for
applications involving salt water or brine! Use
with salt water or brine will void warranty.
Ch. 4 - Installation
DANGER: Risk of electrical shock.
When installing, pump must be
unplugged. See electrical hazard instructions
on Page 2.
1. Set the pump on clean and firm ground
in at least 51mm (2") of water.
2. Connect the discharge line with the
fittings provided.
3. If the discharge hose could freeze it must
be emptied to prevent damage on the
pump.
Figure 1 Unsnap screen with a screwdriver and tap it out of the volute to clean it. Be
sure all the snaps catch when reinstalling it.
Ch. 5 - Operation
DANGER: Risk of electrical shock.
Do not handle the pump with wet
hands or while standing on a wet or damp
surface or in water. See electrical hazard
instructions on Page 2.
DANGER: Risk of electrical shock.
Before attempting to check why a
pump has stopped operating, disconnect the
electrical power to the unit. See General
Information, Nos. 1A to 1G, on Page 2.
1. The shaft seal is water cooled and
lubricated. To avoid seal damage, never
run the pump dry.
2. This pump will not remove all water. On
a flat surface, it will pump down to
within 3.1 mm (1/8") of the pumping
surface.
WARNING: When the pump is running
continuously, keep it submerged to
prevent overheating.
3. This pump has an anti-airlock hole
(see Figure 1). Keep it clean for proper
operation.
Anti-Airlock Valve
(Remove screen
and look under
pump for access)
3
Tabla de contenido
loading

Este manual también es adecuado para:

Od660ichOd660iuk2533sh

Tabla de contenido