Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Preparing for setup:
1. Ensure you are outdoors in an area where the Copilot
during set up. For example, do not perform this set-up in an underground parking
garage.
2. Adjust your car's seat to your desired driving position.
3. The Copilot
TM
(Fig. 2).
Mounting the suction cup on the windshield:
1. Remove the thin plastic film from the suction cup.
2. Clean and dry the area of the windshield where you will mount the suction cup.
3. To secure the mount press the suction cup firmly onto the windshield. Then rotate the
Lock Latch 90 degrees clockwise until the suction cup is locked in place.
4. Plug the mini USB cable into the Copilot
car's cigarette outlet (Fig. 3).
5. Secure the cable along the edge of the windshield and the headliner by using the
adhesive wire clips at each of the circled locations (Fig. 2).
6. Adjust the angle of the device so that it is pointed at the driver's face allowing for
optimal facial reading (Fig.1).
7. The Copilot
TM
driver's seat (Fig. 1).
Note: Depending on your vehicle, use of a sun visor may trigger drowsy or distracted
warnings.
This device has GPS functionality and will detect when the vehicle is in motion. This
feature serves to ensure that the device only provides warnings when the vehicle is moving
at speeds over 10-15 mph. This prevents the Copilot
to the driver when the vehicle is stationary.
If the GPS signal is lost. As a safeguard, the device will provide warnings even when the
vehicle is parked or moving at less than 10-15 mph.
Note: When the GPS signal is recovered the device will resume normal operation when the
vehicle is in motion.
4.
Operation
Power On/Off (Fig. 4)
Power On: The Copilot
power supply or when the power button is pressed. You will hear a voice prompt say
"Welcome to use Fatigue Driving warning device".
Power Off: The Copilot
when the power button is pressed.
Calibrating The Copilot
1. Facial Scanning: Press and hold the power button until the LED indicator light
turns blue. Make sure to wait until you hear "GPS Connected" or "GPS state not
Detected". This may take up to 30 seconds. You will hear a voice prompt say
"Please watch the road ahead and be ready for facial reading."
2. Facial Scan Ongoing: Facial scanning may take more than one attempt. As such,
If you hear a voice prompt say "Reading unsuccessful, be ready for facial reading
again." Then facial scanning is still ongoing and you should be careful not to
should be mounted above the steering wheel in the red highlighted area
should be placed no more than 33 inches from you while you are in the
will automatically power on when connected to an active
TM
will automatically power off when your car is powered off or
TM
For First Time Use (Fig. 5)
TM
can receive a GPS signal
TM
. Then plug the other end securely into your
TM
from needlessly providing warnings
TM
5
Tabla de contenido
