Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Hook-Up Guide (cont' d )
Outlet Box Installation (cont' d )
A) Use a stud finder (available at your local
hardware store) to locate the wall studs near
the location where you wish to install your
In-Wall PowerCenter (close to or behind
the display device). To ensure wire accessibility,
your location should also be vertically aligned
with an existing power source (wall outlet, etc.).
Mark the ideal hole location with dimensions
4 ³ ⁄ ₁₆ " x 3 ⁷ ⁄ ₈ " in between the wall studs. You can do
this by first holding the Two-Gang Outlet Box with
its open face flush against the wall. Use a pencil
to lightly trace the edge of the Two-Gang Outlet
Box, but not the six outer tabs (see Image 1 at right).
Once you have traced the edges, remove the
Two-Gang Outlet Box (Image 2), and use a straight
edge to lightly draw the rest of the edges and
corners (Image 3). Use a ruler to ensure that the
dimensions are 4 ³ ⁄ ₁₆ " x 3 ⁷ ⁄ ₈ " before proceeding.
Drill a small hole in the center of the outline,
and feed one end of a coat hanger through
the hole to check for obstructions. If nothing
is detected, carefully cut out the outlined
rectangle with a drywall saw.
Tabla de contenido
