Rotary Function Switch; Input Terminals - RIDGID micro DM-100 Manual De Instrucciones

have selected, change to a higher range. On some low DC and AC voltage ranges, with
the test leads not connected to a device, the display may show a random, changing
reading. This is normal and is caused by the high-input sensitivity. The reading will
stabilize and give a proper measurement when connected to the circuit.
7. Always turn the function switch to the OFF position when the meter is not in use. The
meter will automatically shut OFF if not used for 15 minutes.

Rotary Function Switch

The Rotary Function switch permits the user to select a measurement function by position-
ing the rotary switch to one of the icons around its perimeter.
Figure 6 – Rotary Function Switch

Input Terminals

The black test lead plugs into the negative (COM) terminal and the red test lead plugs into
any of the three the positive input terminals according to the measurement to be made.
Use the provided terminal plugs in idle terminals during operation.
Figure 7 – Input Terminals
micro DM-100 Digital Multimeter
Switch Position
OFF
Terminals
10 A
µA / mA
V / Hz% /
Ω / CAP /
TEMP
COM
Function
Switch Off the Multimeter
DC/AC Voltage Measurement
Capacitance Measurement
Continuity Check and Diode Test
Resistance Measurement
Frequency Measurement
Temperature Measurement in °C
Temperature Measurement in °F
DC/AC Current Measurement up to
10 A
DC/AC Current Measurement up to
400 mA
DC/AC Current Measurement up to
4000 µA
Description
Input Terminal for 0 to 10 A
Input Terminal for 0 to 400 mA
Input Terminal for DC/AC Voltage
Measurement, Resistance
Measurement, Continuity
Check, Diode Test, Frequency
Measurement, Capacitance
Measurement and Temperature
Measurement
Negative Terminal for all
measurements
13