PROLiNK In-Line Outlet Manual Del Usuario

INSTALLATION
STEP 1: CHOOSE INSTALL LOCATION
This installation will use the power and
linking cords included with your ProLink
light fixtures. Make sure that the 5ft.
power cord will reach the nearest outlet
and that the 18in. linking cord will be able
to reach the nearest light fixture. The
mounting location should be indoors, dry
and able to support the module.
DO NOT ATTEMPT TO INSTALL WITH
THE POWER ON.
NOTE: Should you choose, you can install and
connect this module in between light fixtures, as
it will act as a pass through for power.
STEP 2: MARK SCREW LOCATIONS
With a pencil, mark the screw locations
using the keyholes on either end of the
module for guidance.
MARK
STEP 3: PRE-DRILL HOLES
Pre-drill holes for the screws using the
pencil markings for guidance. Use a 1/16in.
drill bit.
PRE-DRILL
STEP 4: INSERT SCREWS
Insert the screws with a #1 Phillips
screwdriver, leaving 1/8in. beyond the surface.
STEP 5: MOUNT MODULE
Align the keyholes on the module with the
screws and slide it into place. tighten the
screws as needed using only the screwdriver.
MOUNT
STEP 6: CONNECT WITH LIGHT FIXTURE
Insert the linking cord (included with your
ProLink light fixtures) into the port on
the module and connect it with the
closest fixture.
STEP 7: PLUG INTO OUTLET
Insert the power cord into the port the
module. Then, plug the power cord into a
120VAC 60Hz outlet.
EASY-ACCESS OUTLET
When plugging electronics into the
module's outlet, make sure everything is
turned OFF beforehand. When plugged
in, you can turn everything ON. Do not
use extension cords with this outlet if they
cannot be fully inserted.
USB CHARGING
Both ports share 2.4 Amp of total output.
In other words, you can charge one tablet
or two smartphones to full capacity at the
same time.
SPECIFICATIONS:
OUTLET ELECTRICAL RATING ........................................................................... 120VAC, 10A, 1200W
USB OUTPUT TOTAL .......................................................................................................................... 5.0V, 2.4A
IMPORTANT SAFETY INSTRUCTIONS
This product is intended only for use
with lighting fixtures that are specifically
compatible with the ProLink linking
system.
• Do not install the module while plugged
in or with plugged in lighting fixtures.
• Do not alter the connectors in any way.
• Save these instructions for future use.
WARNINGS TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK OR INJURY TO PERSONS:
Never use an extension cord unless the plug can be
fully inserted. Do not alter the plug.
• Read the entire installation procedure before
you begin.
• Not to be used with a dimming circuit or any other
electronically switched control.
• Do not attempt to install the fixture while
plugged in.
• Save these instructions so you can refer to them at
a later time.