PALSON Diablo Plus Modo De Empleo página 18

GB
6.2. Control panel instructions for use and operating mode
The following steps are very important: be sure not to press the wrong buttons on
the remote control!
1. You must recheck the code on the remote control or main unit when you change them after first
use or during maintenance.
2. Check that the battery in the remote control and in the main unit have sufficient charge; turn off the
main unit; press and hold OK on the remote control for more than 4 seconds and then turn on the
main unit without releasing the OK button. When you hear the robot beep twice, release the OK
button to complete the code test.
3. If you do not hear the beeps during code testing, repeat the previous steps.
34
All manuals and user guides at all-guides.com
Operating guide
Turn on the machine; when you press the Start/Stop button, the machine will
Start/Stop
start working, and pressing it again will turn the machine off.
1. Turn on the machine.
2. When you press " ", the current time number 88 will start flashing. Use
the ▲▼ buttons to select time.
3. When you press the ◄ ► buttons, the minute indicator will start flashing.
Setting the current Use ▲▼ to set the minute.
date and time 4. Then press ◄ ► to set the hour.
5. To set the day of the week, press one of the buttons SUN, MON, TUE,
WED, THU, FRI or SAT.
6. Once you have configured the setting, press OK.
7. Pressing the on button during configuration cancels the setting.
Setting days of the week for cleaning:
1. Turn on the machine.
2. Pressing " ", SUN, MON, TUE, WED, THU, FRI or SAT will appear.
3. Press any given day of the week, several days or all days to set the device
to clean on any one, several days or every day of the week. The current
date will flash.
Setting the cleaning time:
4. Press " "; the number 88 will start flashing. Use the ▲▼ buttons to
select your desired hour of cleaning.
5. Press ◄ ►, again; the number 88 in minutes will start flashing. Use ▲▼
to set your desired minutes of cleaning.
Setting cleaning time
6. Once you have configured the setting, press OK.
Setting continuous
7. Pressing the on button during configuration cancels the setting.
cleaning
Setting continuous cleaning
If you have a large house, you can use function "
in which the robotic vacuum will start cleaning when fully charged and return
to the docking station automatically before its battery is flat.
1. Press " "; the "
start flashing.
2. Once you have configured the setting, press OK.
3. The robotic vacuum will start cleaning automatically when the battery is
charged (charging time is about 5 or 6 hours).
Note: The continuous cleaning and scheduled cleaning functions
cannot be used at the same time!
If you are certain that there is an error with the device, with the remote control
within range, press this function button on the remote. The screen will show
Error display
an error code which you should be able to clear by following instructions in
the troubleshooting section.
Press "FAST" or "SLOW" to select either fast or slow cleaning. The machine will
Speed selection
automatically save your selection for future use.
Operating information
" (continuous cleaning),
" indicator on the remote control LCD screen will
35