Setup Menu - Briteq Powermatrix 5x5 RGB Manual De Instrucciones

ENGLISH

SETUP MENU

With the setup menu you can fully configure the projector. All settings are preserved when the unit is
disconnected from the mains.
Browsing the setup menu:
General instructions for setup.
 Press the MODE button or UP/DOWN
buttons to browse
functions of the setup menu until the
required function is shown on the
display.
 Press the ENTER button to access the
function and change its parameters.
 The cursor of the value to change
starts blinking. Use DOWN and UP
button to change the value.
 Press the ENTER button again confirm
and select the next parameter to
adjust.
DMX MODE + ADDRESS
Used to set the DMX channel mode and start address.
 Press the MODE button until "DMX MODE" is shown on the display.
 Press the ENTER button: the channel mode (number of channels used) can be set.
 Use DOWN and UP buttons to change the value to the desired channel mode:
 4 CH: RGB+Dim/sound for all 25pixels together (compatible with POWERPIXEL4/8)
 5 CH: RGB+Dim/sound+Strobe for all 25pixels together (compatible with POWERPIXEL4/8)
 6 CH: Control of internal effects library (6 FX-channels)
 11 CH: RGB+Dim/sound+Strobe+FX for all 25pixels together (as 5CH but with 6 extra FX-channels)
 25 CH CW: 25x channels with pre-calibrated RGB-values to emulate 25 pixels 4500K cold white.
 25 CH WW: 25x channels with pre-calibrated RGB-values to emulate 25 pixels 3000K warm white.
 75 CH: all pixels with separate RGB control (pixel mapping)
 81 Ch: all pixels with separate RGB control (pixel mapping) + 6 extra FX-channels.
 100 Ch: all pixels with separate RGB + DIM control (pixel mapping)
 106 Ch: all pixels with separate RGB + DIM control (pixel mapping) + 6 extra FX-channels.
 125 Ch: all pixels with separate RGB + DIM + STROBE control (pixel mapping)
 131 Ch: all pixels with separate RGB + DIM +STROBE control (pixel mapping) + 6 extra FX-channels.
 Press the ENTER button: the start address can be set, the display shows start + end address: "xxx-yyy".
 Use DOWN and UP buttons to adjust the start address (xxx).
Note: Depending on the channel mode, the end address (yyy) of the projector changes automatically. This
makes it easy for you to set the start address of the next projector in the DMX-line.
SLAVE MODE
Used to set the projector in slave mode: the projector copies the output of the master in the line.
 Press the MODE button until "SLAVE MODE" is shown on the display.
 Connect the projector to a master.
Note: only to be used when the DMX-line in exclusively equipped with POWERPIXEL5x5-RGB projectors.
SOUND MODE
Used to set the projector to standalone sound mode with different chases playing in endless loops.
Press the MODE button until "SOUND MODE" is shown on the display.
 Press the ENTER button: the sensitivity of the microphone (SENS) can be set from 00 to 31.
 Use DOWN and UP buttons to change the value.
 Press the ENTER button: the repetition rate (FQN) of the chases can be set from 00 to 99.
 Use DOWN and UP buttons to change the value.
BRITEQ
®
the different
6/83
OPERATION MANUAL
POWERMATRIX5x5-RGB