Safety Instructions; General Introduction; Put The Batteries In; Programming The Appliance Code - Medion ND 4689 Manual De Instrucciones

Univ-FB MD 4689 ML.book Seite 16 Mittwoch, 5. Juli 2006 9:46 09

SAFETY INSTRUCTIONS

Do not expose your remote control to the dust, the sun, humidity, high temperatures
or strong vibrations.
Never mix old and new batteries together.
Do not clean the product with a corrosive or acid solution.
Do not try to repair the remote control by your own.
Do not watch with optical tools.

GENERAL INTRODUCTION

This remote control is designed to control up to 8 devices such as:
TV Television with Videotext
VCR Video Camera Recorder
DVD DVD player
CD CD player
ASAT Analog Satellite
DSAT Digital Satellite
CBL Cable
AUX Auxiliaries (TV, VCR, SAT, CD, DVD,...)
Please read this user guide carefully before using the remote control. Put it in a safe
place, in case you would need to read it again or to give it to a third person.

PUT THE BATTERIES IN

The remote control works with 2 LRO3 batteries. We advise to use alkaline units.
1. Open the cover on the back of the remote control
2. Check the "+/-" polarity on the batteries and inside the compartment
3. Insert the batteries
4. Close the cover.
If the batteries are changed, a new setup may be necessary. We advise you to write
your appliance code on this user guide. Do not throw batteries in the general
household waste disposal. They must be thrown in specific collectors.

PROGRAMMING THE APPLIANCE CODE

The code of the appliances you wish to control are included in the code list here
enclosed. Look up the brand of your appliance and note the code numbers.
Switch on manually the appliance you wish to control.
1. Press and hold the "SET" key for 3 sec. about, until the LED indicator lights
continuously.
2. Release the "SET" key.
3. Press and release the mode key of the device you wish to control (TV, VCR,
DVD, CD, SAT, AUX).
4. Enter the 3 digit code from the library table. The LED turns off after the each
press.
5. If you entered the code correctly, the LED turns off after the last digit press. If
incorrectly entered, the LED blinks for 3 seconds and then goes off.
6. The code entry is finished..

CODE SEARCH (MANUAL SEARCH)

If you have tested all the available codes for your type of appliance and brand, and
if your equipment does not respond to the remote control, try the automatic code
search. By this way, you may find the code of your appliance, even if your brand is
not included in the code list.
1. Switch on manually the appliance you wish to control (TV, VCR etc...)
2. Press and hold the "SET" key for 3 sec. about, until the LED indicator lights
continuously.
3. Release the "SET" key.
4. Press and release the mode key of the device you wish to control (TV, VCR,
DVD, CD, SAT, AUX).
5. Press repeatedly (up to 350 times) "POWER" or "CHAN+" or "PLAY" (only for
a VCR), until the appliance turns off or reacts normally.
6. Briefly press "OK" button to stock the code.
EN-16