Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
Ensure that all packaging material is kept out of reach of children.
Children and vulnerable people should be alerted to the hazards of high surface
temperatures and should stay away to avoid burns, clothing ignition, or other
serious personal injury.
Always disconnect the heater from the electricity supply and allow adequate
time for it to cool to room temperature before adjusting the position or
attempting to work on it.
Do not touch any part of the heater or plug with wet or moist hands.
Do not cover the heater.
Installation must be carried out by a qualified and licenced person only.
After unpacking, make sure the appliance shows no signs of visible damage or
tampering. If the appliance appears damaged, contact the place of purchase for
assistance.
This heater must only be used on a 220-240V AC single phase electricity
supply.
Remove packaging and any transit protection before installation.
The installer is to ensure that the requirements of the local authority, local
electrical installation code, municipal building codes, and any other relevant
statutory regulations are carried out.
Do not run the power cord under carpeting. Do not cover with throw rugs,
runners, etc. Arrange the cord away from all taraffic areas and where people
will not trip over it.
Keep the cable away from sharp edges during handling and installation.
Do not allow the supply cord to sit or hang in front of the heater while in
use and keep it away from the body of the heater which will get hot during
operation.
Do not use or install the heater in bathrooms, laundry areas, or similar indoor
locations. Never place the heater near a bathtub or other water container. Do
not place switches or controls within reach of a person in a bathtub, shower, or
swimming pool.
Do not locate the heater immediately above or below a fixed socket outlet or
connection box. This is because the heat radiated from the appliance may
damage the electricity outlet or plug.
This heater must be grounded. Connect to properly grounded outlets only.
Ensure both plug and socket is clean and free from dust when using.
To disconnect the heater from the power supply, grip the plug and pull from the
power socket. Never pull by the cord.
Always plug directly into a wall socket. Never use with an extension cable as
overloading may result in the cable overheating and catching fire.
4
Tabla de contenido
