Tabla de contenido
S16 Getting started
(EN) Step 3: Getting
started
Before powering the unit on, make all
audio and digital connections.
Turn on the power.
The default configuration is active when
all status LEDs above the CONFIG button
are off (see Seq . 1 in Operation
Mode Chart). If your application requires a different
output setup, press and hold the CONFIG button to
enter configuration mode. While pressing the
CONFIG button, turn the SELECT/ADJUST knob to
scroll through the items. You can select from the
following options:
• Engage the SN MASTER function to designate
the master unit when using two S16 units in a
standalone snake application. This is available in
4 modes, 44.1 kHz and 48 kHz, each with Splitter
mode engaged or disengaged.
• Engage the SPLITTER function to send the
16 local input signals directly to the ADAT OUT
and P16 jacks. When the SPLITTER function is
disengaged, the ADAT OUT jacks carry AES50
channels 17-32 and P16 carries channels 33-48.
• Select whether the OUTPUT jacks 1-8 carry the
AES50 channels 1-8 (LEDs off), 9-16, or 17-24 by
engaging the OUT +8 or OUT +16 function.
Quick Start Guide
Release the CONFIG button to exit
configuration mode. See the Operation
Mode Chart for more details.
Repeatedly press the SELECT/ADJUST
knob until the left side of the display
shows "In". Turn the SELECT/ADJUST
knob to select one of the inputs 1-16.
Press the 48 V button to toggle the
selected channel's phantom power
on/off, if necessary.
Press the GAIN button. The button will
light, and the gain can now be adjusted
with the SELECT/ADJUST knob. Turn the
knob to the right until the loudest peaks in your
speaking or playing cause the -9 dB LED to light
briefly in the meter.
With headphones connected to the
PHONES jack, turn the adjacent
MONITORING LEVEL knob up to a
comfortable listening level.
27
Tabla de contenido
