mixars Primo Manual Del Usuario página 8

In non-Serato mode routing, the Primo works as a MIDI control with standalone external mixer that the
mixing is done by Primo hardware.
The non-Serato mode Audio routing:
There are different ways to switch between the 2 audio routings:
1. When Serato DJ software is open and initiated, it will trigger the connected Primo to change to
Serato mode routing automatically.
2. Or, press and hold the NOSIE button and FILTER button and power on the Primo. Wait for a few
seconds until the left or the right PFL button is lit in blue. Release SHIFT button.
3. Press either one PFL button to select the audio routing:
Right: Serato Mode
Left: Non-Serato Mode
The corresponding PFL button should be lit in blue
4. Press SHIFT to confirm the choice and the Primo will be ready to use.
The audio interface is a 6-in 12-out interface with assignment:
CH Inputs
1 Deck 1 in L (DVS)
2 Deck 1 in R (DVS)
3 Deck 2 in L (DVS)
4 Deck 2 in R (DVS)
5 Record in L
6 Record in R
7 NA
8 NA
9 NA
10 NA
11 NA
12 NA
USB 9/10
CUE from DJ Software
Outputs
Deck 1 out L
Deck 1 out R
Deck 2 out L
Deck 2 out R
Deck 3 out L
Deck 3 out R
Deck 4 out L
Deck 4 out R
CUE out L
CUE out R
Sampler out L
Sampler out R
7