Tabla de contenido
SPECIFICATIONS
Blind rivet setting capacity
Traction power
Air pressure
Average air consumption
Air inlet
Hose size
Weight
UNPACKING
When unpacking, check to make sure the following parts are
included. All sizes listed below are approximate.
•5/32" Nose piece
•1/8" Nose piece
•3/32" Nose piece
•Jaw case front tart (3/32" 1/8" 5/32")
•Jaw case end tart
•Jaw
•Jaw pusher
•Jauw pusher spring
•Reium spring
•Spanner
•3 way spanner
•Quick coupler
Quick
Connector
Air
Tool
Quick
Coupler
OPERATIONS
ATTACHING THE AIR INLET
Use the quick coupler and screw it to the air inlet receiver.
SETTING UP AIR COMPRESSOR AND AIR DELIVERY LINE
STEP1: It is advisable to use an in-line oiler.
STEP2: If you are not using an in-line oiler, put a few drops of pneumatic oil into
the quick coupler prior to every operation.
CHANGING NOSE PIECES
When changing NOSE PIECES simply unscrew the NOSE PIECE, and tightly screw
in the desired NOSE PIECE. (The unit comes with the 3/16" NOSE PIECE.
MAINTENANCE & ADDING OIL FOR HYDRAULIC RIVETER
1. Disconnect air hose.
2. Use the spanner to take apart the head as fig.1
3. Use the spanner to open the bottom cover as fig.2
4. Remove the piston of the cylinder as fig.3
5. Clean the inside of the cylinder and the frame body.
fig1
3/32" 1/8" 5/32" 3/16" (2,3 mm 3,1 mm 3,9 mm 4,7 mm)
OILER AND FILTER CONNECTION
Dirt, water and the lack of pneumatic tool oil are
major causes for tool wear. Install an optional
oiler-filter, as illustrated below for better
performance.
1. Connect air tool, air hoses, filter and oiler to the
Compressor air Outlet as illustrated below.
The filter and oiler (not supplied) are recommended
but not mandatory for operation.
If the filter and oiler are not used, connect the air
hose directly to the 1/4 inch, 18 NPT connector located
at the Air Inlet fitting. Also a few drops of pneumatic
tool oil must be added through the air before each
use.
Quick
Quick
Connector
Coupler
Air
Hose
6. Full the lubricate oil as fig.4
7. Clean the stem of piston, apply grease to the inner
wall of cylinder and the O-ring as fig.5
8. Reassemble the riveter by following the diassembly
procedure in reverse.
fig2
fig3
60 - 90 PSI (413 - 620 KPa)
4 a 4,5 CFM (0,04 a 0,045 L/min)
Oiler
Filter
Regulator
fig4
720 kg (1 586 lb)
1/4" NPT (6,3 mm)
3/8" ID (9,5 mm)
3,74 lb (1,69 kg)
NOTE: Use pipe thread
seal or teflon tape on all
threaded connections.
Air
Compressor
Frame
Head
Nose
Piece
Air Inlet
Receiver
fig5
2
Tabla de contenido
