Use In Stroller; Handle Adjustment; Adjust The Correct Harness Height; Harness Adjustment - Belluno Baby GUBBIO BL-64 Manual De Instrucciones Para Armado Y Uso

USE IN STROLLER

1. Place the side adapters of the car seat on each side of the car seat, below the
handle, until a CLICK confirms the secure engagement.
2. Position the car seat inside the stroller frame, with the adapters on the side
inserts of the chassis.
3. A "CLICK" will indicate that the car seat is correctly secured.
4. Always check that it is correctly positioned in place and does not come off or
move.
5. To remove it from the frame, press the release button.
Adapters

HANDLE ADJUSTMENT

1. Simultaneously press the adjustment buttons (RED color) located at both ends of
the handle, and move the handle to the desired position.
2. In parallel, rotate the handle until it locks in one of its three positions:
• Top: MUST be used when carrying from the handle.
• Intermediate: Allows the baby to be rocked.
• Lower: Achieve a sitting position.
3. BOTH handle adjustment buttons must pop out to lock the handle in place. If you
are going to use the restraint system in the car, the handle must be in its upper
position. Once in the rear seat, push and pull on the handle to make sure it is firmly
locked.
28

ADJUST THE CORRECT HARNESS HEIGHT

• For your child's safety, please check the height of the shoulder strap frequently.
• In the rear-face installation of any restraint system, the safety harness should
come off at or just below the child's shoulder. It should NEVER go out over it.
• Release the harness anchor belts at the rear of the seatback so that you can select
the correct height for the safety harness to pass through.
Release button

HARNESS ADJUSTMENT

1. Adjusting the seat belt straps allows the baby to always be well secure in the car
seat. Pull the straps at the rear, and adjust the fit of the seat belt over the child.
Depending on the baby's body, you will need to adjust or release the strap.
2. Pull on the shoulder straps while pressing the button on the central harness
adjuster. In this way, you can adjust the belt by pulling the strap to adjust or the
shoulder straps to release.
3. The shoulder strap should be adjusted to the proper degree of tension. A shoul-
der strap that is too tight will cause discomfort; if it is too loose can be dangerous.
Too high Correct
Seat body
Harness slot
Too Low
Belt slot
Safety harness
anchor
29