Resetting The Plug; Using The Product; If You Have An Android Smartphone With Google Assistant - THOMSON PLUG-O 520006 Manual Del Usuario

5 - RESETTING THE PLUG

The following instructions may help you if you have
any problems during the pairing procedure:
To carry out a RESET, plug in the plug and unplug
it three times in less than 2 seconds; the pairing can
then be done again, ensuring that the 2 red and
blue LEDs are on before unplugging and plugging
the plug back in again. The plug must also be
deleted from the application. If the operation was
successful, the blue indicator will start to flash slowly.
If not, start the procedure again.
1 - USING THE PRODUCT WITH GOOGLE
HOME
Google Assistant can help you control your
connected devices.
For example, you can use the following commands:
- "OK Google Turn off the office lamp"
- "OK Google" Activate the office lamp
For more information on device names or creating/
linking a room, please consult Google support.
One tip however: if you connect multiple modules
within the same zone, and to prevent unwanted
commands, we recommend you do not use
the group name suggested by Google Home
(bedroom, office, living room, etc.) when naming
your control module.
In the event of problems with the Google Home
application or configuration of the device in Google
Home, contact Google support.
OUTDOOR WI-FI SMART PLUG
The LED located on the smart plug gives the
following indications:
- LED lit up blue: The plug has power but is not
delivering any current
- LED lit up red: The plug is delivering current
- Fast flashing: The plug is in pairing mode
- Slow flashing: The plug is connecting to the server.
D - USING THE PRODUCT
The setting up procedure depends on your
smartphone and requires an Internet connection:
1.1. If you have an Android smartphone with Google
Assistant.
Your devices need to be paired in the Thomson At
Home app to be controlled with Google Assistant.
They must be connected on the same WiFi network.
• Connect the devices to Google Assistant:
- On your Android tablet or phone, long press
the home button or say "OK Google".
- In the lower right-hand corner, press
- Press the logo at the top right, then Settings
> Assistant > Home control.
- In the "Devices" tab, press Add devices .
- Select the Thomson At Home app then follow
the instructions.
- Once successfully linked, press OK.
Your product is now connected in Google Assistant
and you can use voice control with it.
C - INSTALLATION
.
9
EN