Important Safety Instructions - GreenWorks Commercial GE 080 Manual Del Propietário

IMPORTANT SAFETY INSTRUCTIONS

W A R N I N G
Read and understand all instructions before using this product. Failure to follow all
instructions listed below may result in electric shock, fire, and/or serious personal injury.
• Use only identical manufacturer's replacement parts and accessories. Use of any other parts
may create a hazard or cause product damage.
• Always wear safety glasses with side shields marked to comply with ANSI Z87.1. Everyday
glasses have only impact resistant lenses. They are NOT safety glasses. Following this rule
will reduce the risk of eye injury. Use face mask if operating in dusty work spaces.
• Avoid Dangerous Environments — Don't expose power tools to damp or wet conditions. Water
entering a power tool will increase the risk of electric shock.
• Don't use in rain.
• Keep all bystanders, children, and pets at least 50 ft. away.
• Do not use the power tools for any job except for which it is intended.
• Avoid Unintentional Starting – Do not carry the edger with fingers on the switch. Be sure the
battery is removed while transporting.
• Do not operate the equipment while barefoot or when wearing sandals or similar lightweight
footwear. Wear footwear that will protect your feet and improve your footing on slippery
surfaces.
• Don't overreach - Keep proper footing and balance at all times.
• Stay alert - Watch what you are doing. Use common sense. Do not operate this unit when you
are tired, ill or under the influence of alcohol, drugs or medication.
• Always store idle power tools indoors - When not in use, power tools should be stored indoors
in a dry place, out of reach of children.
• Power tool maintenance – Replace blade if cracked, chipped, or damaged in any way. Be
sure the blade is properly installed and securely fastened. Keep cutting edge sharp and clean
for best performance and to reduce the risk of injury. Follow instructions for lubricating and
changing accessories. Keep handles dry, clean, and free from oil and grease. Failure to do so
can cause serious injury.
• Check Damaged Parts – Before further use of the power tool, a guard or other damaged
parts should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment of moving parts, binding of moving parts, breakage of
parts, damaged mountings, and any other condition that may affect its operation. A guard or
other damaged parts should be properly repaired or replaced by an authorized service center
unless indicated elsewhere in this manual.
• Do not charge or operate cordless tools in damp or wet locations or in the rain. Following this
rule will reduce the risk of electric shock.
• Remove or disconnect battery before servicing, cleaning or removing material from the power
tool.
• Do not dispose of the batteries in a fire. The cells may explode. Check with local codes for
specific disposal instructions.
3