IMS Welding SPOT LIFT Instrucciones De Montaje página 10

OPERATING INSTRUCTIONS
After connecting the jack's power supply and reviewing the precautions to be taken as well as the warnings, proceed
as follows:
The tool must be used only for vehicles with a weight inferior to 2.5T
2.5 t max.
It must not be used for vehicles equipped with a panoramic roof, that can be damaged during lifting.
Lifting:
• Before lifting, verify that the tyres' pressure is sufficient to maintain the vehicles'
balance.
• Check that the vehicle is blocked with the handbrake on. Check its efficacy.
• Position the jack so the fork is well adjusted on the sides of the wheel.
I • f using the lifting accessory for the lower body frame, check its positionning.
• Always check the good function of the lifting accessorries before lifting a vehicle.
• To raise the vehicle, action the pump by pressing on the pump's pedal on side A
• When the desired height is reached, release the pedal and secure the load by
placing the safety axis in the safety notch of the column.
• For extra safety, always place axle stands below the vehicle, in order to support
it.
• Press on the pump's pedal on side B so the load comes to rely on the safety axis.
Do not raise the jack above the maximum marker, to avoid reaching the end of the jack's course
(check picture below)
Lowering :
• Press the pump's pedal on side A to relase the safety axis.
• Remove the safety axis from its hole in the column
• Press the pump's pedal on side B to lower the vehicle to the ground or at the
desired height
• Remove the jack from the vehicle only once the jack is completely lowered.
• The vehicle can then be moved.
Hydropneumatic pump
10
In case of prolunged non use, lower the jack to the ground.
Never leave the load unattended while raised.
B
A
SPOT LIFT
Maximum height marker, do not go further
EN
A
B