Ego Power+ CS1800E Manual Del Operador página 11

TROUBLESHOOTING
PROBLEM CAUSE
◾
The battery pack is not attach the
battery pack to the chain saw.
◾
No electrical contact between the saw
and battery.
◾
The battery pack is depleted.
◾
The battery pack or chain saw is too
hot.
Motor does not start.
◾
Chain brake is engaged.
◾
Debris in bar groove.
◾
Debris in side cover.
◾
The chain saw is overloaded.
◾
The battery pack or chain saw is too
hot.
Chain saw stops
running during working.
◾
Saw chain is bound in the wood.
◾
Chain does not engage drive sprocket.
Motor runs, but chain
◾
does not rotate. Debris preventing full movement of the
chainkickback brake handle.
◾
Possible chain brake malfunction.
SOLUTION
◾
Attach the battery pack to the chain saw.
◾
Remove battery, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Allow the battery pack or chain saw to cool
until the temperature drops below 67 °C.
◾
Pull the chain-kickback brake handle
backward toward the front handle, arriving
at the operating position.
◾
Press the saw chain against the wood,
move the chain saw back and forth to
discharge the debris.
◾
Remove battery pack, then remove side
cover and clean out debris.
◾
Decrease the load.
◾
Decrease the load. Allow the battery pack
or chain saw to cool until the temperature
drops below 67 °C.
◾
Release the trigger switch; remove the saw
chain and guide bar from the wood,then
restart the chain saw.
◾
Reinstall the chain, ensuring that the drive
links on the chain are fully seated onto the
sprocket.
◾
Debris preventing full movement of the
chainkickback brake handle.
◾
Contact EGO Customer Service for repair.
CORDLESS CHAIN SAW — CS1800E
EN
11