Safety Information - Enerpac BRP-302 Hoja De Instrucciones

IMPORTANT RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage. If any shipping damage is found, notify carrier at
once. Shipping damage is NOT covered by warranty. The carrier is responsible for all repair or replacement
costs resulting from damage in shipment.
DESCRIPTION
Enerpac Pull-pac cylinders use hydraulic pressure to produce a pulling or tensioning force. Typical
applications include tension testing, weight measurements, tightening tension lines, or as a replacement
for conventional ratchet cable pullers, in situations where high force is needed over a short stroke.

SAFETY INFORMATION

To avoid personal injury or property damage during system operation, read and follow all CAUTIONS,
WARNINGS, and INSTRUCTIONS included with or attached to each product. ENERPAC CANNOT BE
HELD RESPONSIBLE FOR DAMAGE OR INJURY RESULTING FROM UNSAFE USE OF PRODUCT,
LACK OF MAINTENANCE, OR INCORRECT PRODUCT AND SYSTEM APPLICATION. Contact Enerpac
when in doubt as to applications and safety precautions.
WARNING
DO NOT DISASSEMBLE THE CYLINDER. The stop ring is spring loaded and could cause
serious personal injury if the cylinder is not disassembled properly. For repair service,
contact the authorized Service Center in your area.
WARNING
To avoid personal injury, always wear proper personal protective gear when operating
hydraulic equipment (i.e. safety glasses, gloves, etc.).
WARNING
The system operating pressure must not exceed the maximum pressure rating of the
lowest rated component in the system.
WARNING
Never overload the cylinder. Pulling a load that exceeds the capacity of the cylinder may
cause equipment failure and serious personal injury.
WARNING
Make sure that all system components are protected from external sources of damage,
such as excessive heat, flame, moving machine parts, sharp objects, corrosive chemicals.
DO NOT expose equipment to temperatures of 150°F (65°C) or more.
CAUTION
DO NOT use the hydraulic hose to carry or drag a hydraulic component, because damage
the hose or the component may occur.
CAUTION
Use less than the maximum rated stroke. Operating the cylinder beyond the limits of its
rated stroke can damage the cylinder.
2