West Elm laquered thin shelf Instrucciones De Ensamblaje

NOTE :
• Maximum Load is 10lbs for drywall and 20lbs for stud
mount.
• The hardware included is meant for drywall or
stud mounting only.
• Designed to be used for decorative items only.
• Wipe with a soft, dry cloth. To protect the finish, avoid
the use of all chemicals and household cleaners.
0/2/0
laqué plateau mince
plataforma delgada lacado
le fait de monter des instructions
! For drywall mounting, use anchors with screws. For
stud mounting, use screws only.
1. This shelf comes with a paper mounting pattern which
can be used to locate the position of the shelf on your
wall and mark the insertion points of the mounting
hardware. The template outline indicates the line of the
shelf edge at the wall. The centerpoints are toward the
top of the shelf and indicate the point of insertion for
the drywall anchors and screws.
2. Temporarily tape the mounting pattern to the wall with
the outline indicating the desired location of the shelf.
3. Using a pin, poke through the mounting pattern into
the drywall at the center points to mark the locations
on the wall. Remove the mounting pattern.
4. For stud mounting, skip to step 5. For drywall
mounting: using a phillip's head screwdriver, insert the
snapskru(a) into the wall at the insertion points. Turn
clockwise until snapskrus are flush with the wall.
5. Put the screw hole on the metal hanging hardware
matching with snapskru(a). Insert screws(b) into screw
hole and anchors, and turn clockwise until screw and
product are flush with the wall.
6. Align keyhole notches on the back of the shelf over the
screw head and slide the shelf down until it rests on the
screws. Tighten or loosen screws as needed to fit the shelf
snugly against the wall.
laquered thin shelf
assembly instructions
instrucciones de montaje
a. snapskru 2x
b. screw 2x
Page  of 3