Memory Mode - CICLOSPORT CICLOPULS CP13is El Manual Del Propietario

To start the stopwatch, select the stopwatch function by
pressing the Mode button and then press the Set button
(the memory function will be started at the same time).
Press the Set button again (in stopwatch mode) to stop the
stopwatch (and also the memory function).
The times recorded within the set limits may be recovered
in the Memory mode (ref. subsection 5.3) by repeatedly
pressing the Set button.
To reset the stopwatch to zero (and, at the same time, the
training times, average and maximum heart rates), press
and hold the Set button for 3 seconds in the stopwatch
mode.
Warning: this will also cancel the stored values.
Whilst the values are being recorded, it is always
possible to recall another function without stopping
the stopwatch.
The stopwatch works up to a maximum value of 23:59:59
hours. When this value is reached the stopwatch will stop.
32

5.3 Memory Mode

Press the Set button several times
to recover the values stored. The
current heart rate is always shown
at the same time in the lower part of
the display.
The following information appears on the display:
- training times within the limit
values set for the heart rate
- training times above the upper
limit values set for the heart rate