Cleaning The Nozzle - PowerCare Pump-N-Vac Manual Del Usuario

For high-volume pumping mode:
NOte: When using the Pump-N-Vac for pumping, it is not
necessary to use the trigger handle. The spray wand may
be connected directly to the high pressure hose on your
pressure washer (if compatible).
NOte: Depending on your model, a 3/8 in. quick connect
to M22 adaptor (AP31040) may be needed.
n Insert the Pump-N-Vac inlet plug into the spray wand
quick connect coupler and secure.
n Secure a 1-1/2 in. discharge hose to the high-volume
hose adaptor with a hose clamp (not provided) and trail
away from the work area. This is where the water that is
pumped out will drain.
n Start your pressure washer as described in your pressure
washer manual.
n Submerge the Pump-N-Vac into the standing water you
wish to remove.

cleaNiNg the NOZZle

See Figure 4.
If the Pump-N-Vac begins to move water more slowly, the
nozzle may be clogged.
n Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
n Disconnect Pump-N-Vac from spray wand.
n Using a flat blade screwdriver, wedge the securing pin
up until you can grasp it. Remove the securing pin.
n Using a Torx screwdriver, remove the Torx screws and
set aside.
n Remove the nozzle assembly from the tube.
n Using a straightened paper clip or nozzle cleaning tool
(not provided), free any foreign materials clogging or
restricting the nozzle.
n Using a garden hose, flush debris out of nozzle by back
flushing (running the water through the nozzle backwards
or from the outside to the inside).
NOte: Also check the tube of the Pump-N-Vac to be sure
no debris is clogged there before reassembling.
n Reinstall the nozzle into the Pump-N-Vac. Reinstall Torx screws and securing pin.
n Reconnect the Pump-N-Vac to the spray wand.
n Turn on the water supply and start the pressure washer.
techtrONic iNDustries NOrth america, iNc.
pump-n-vac
in pumping mode
straightened
paper clip
Hwy 8
Pickens, SC 29671
1-866-340-3912
hose clamp
nozzle
assembly
securing pin
Fig. 3
torx screws
nozzle
tube
Fig. 4
987000-573
3-20-09 (REV:02)