Installation - Primo 900138 Manual Del Usuario

All manuals and user guides at all-guides.com

INSTALLATION

To prevent accidental tip hazard, dispenser must be securely anchored to wall as
shown.
1. Place dispenser upright.
2. Locate dispenser on a hard and level surface
in a cool shaded location near a grounded
wall outlet.
Notice: Do NOT plug in power cord yet.
3. Position dispenser so the back is at least 4
inches from wall and there are at least 4
inches of clearance on both sides.
4. Install Wall Mount Strap to prevent accidental
tip over:
Unclip strap from back of dispenser
-
Mount strap 25" up from floor directly to
-
wall stud with screw (See illustration A)
If stud is not available, insert and turn
anchor directly into sheet rock using a
Philips screwdriver (DO NOT drill hole into
sheet rock first when using this anchor).
Secure strap by installing screw through
washer, then eyelet in strap and into wall
mounted anchor. (See illustration B)
Position cooler in place
-
Clip strap onto back of cooler to right or
-
left side. (See illustration C)
Adjust length of strap so the dispenser can
-
NOT move forward.
Note – Dispenser can be positioned in a corner
but still requires Wall Mount Strap to be
installed. Lengthen strap so that once installed
the dispenser cannot move forward.
Model # 900138: Page 6
A
B
C