Tabla de contenido
GUIRNALDA E14
CODE
392105
392112
IP44
230V
WARNING
BEFORE STARING THE INSTALLATION OF THIS PRODUCT
, PLEASE READ ATTENTIVELY THE INSTRUCTIONS AND
KEEP THEM IN A SAFE PLACE.
THE INSTALLATION SHOULD BE PERFORMED BY QUALI-
FIED PERSONNEL.
THE IMPROPER HANDLING OF THE COMPONENTS
OR THE PRODUCT COULD DAMMAGE THE CORRECT
FUNCTIONING OF THIS DEVICE THUS CANCELLING THE
WARRANTY OF THE PRODUCER
THE WARRANTY OF THE PRODUCER IS CANCELLED IF
THE INSTALLATION IS NOT PERFORMED FOLLOWING
THE INDICATED IN REBT 2002.
THE APPLICATION ITC BT09-4 OF THE REBT IS MANDA-
TORY (INSTALLATION OF OVERVOLTAGE PROTECTORS
OF IN LINES AND RECEIVERS) FOR INDUSTRY INSTALLA-
TIONS AND PUBLIC LIGHTING. THE WARRANTY DOES
NOT COVER DAMMAGES PRODUCED BY OVERVOLTA-
GE ON RECEIVERS WITHOUT OVERVOLTAGE PROTEC-
TORS.
THE APPLICATION OF ITC BT19 ( INTERIOR OR RECEI-
VING INSTALLATIONS.GENERAL PRESCRIPTIONS) IS
MANDATORY.
THE APPLICATION OF ITC BT34 (INSTALLATIONS FOR
SPECIAL PURPOSES. FAIRS AND STANDS) IS MANDA-
TORY.
MAINTENANCE OF THE PRODUCT
ALL PRILUX CHRISTMAS LIGHTING MOTIF, NEED A
MAINTENANCE BEFORE BEING USED, IT MEANS TO
CHECK ALL THE CONNECTIONS (INCLUDED THE END
CAP) IN ORDER TO BE SURE THAT THE MATERIAL HAS
THE PERFECT TIGHTNESS.
CONSUMPTION MAX. LAMPHOLDERS
20W
5W
25cm
15m
25cm
50m
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
CABLE COLOR
Black
Black
WARNINGS AND PRECAUTIONS:
• If you use this product indoors, be aware that this product uses a 230V
power. a notice of discharge protection indoors necessary.
• This product is designed for decorative purposes.
• Keep out of reach of children and animals.
• This product can not be immersed in liquid or installed when it is raining.
• If the starter cable is connected to the outdoors, ensure that the external
earth or junction box is completely waterproof.
• If the product is damaged, discard the whole.
• LED bulbs can be replaced.
• Do not place this product near heat sources.
• This system is suitable for long-term outdoor use if you follow the instruc-
tions.
• Keep this information sheet for the future.
WARNING - BEFORE ATTEMPTING TO OPERATE
• Check that the product does not have any damage or defect before
connecting to the mains.
• Check that each cap has a waterproof rubber seal mounted securely. If
any board is missing, the product should not be used.
• I make sure the ring all the plugs, and the cap are in place.
• Check inside each cap to the copper terminals are both in the correct
position. One should be flat on the bottom and the other must be up (Fig.1).
• If you find a cap with the two terminals pointing up, one down curve to
match take next 'Only do this with unplugged garland !!
• Before installation, test all caps are functioning properly.
• This product should not be modified. If cuts are made, or wreath plugs are
removed, the warranty is void and make the product unsafe.
• Ensure that the current is compatible with this product before use.
WARNING: THIS PRODUCT IS AND IS HIGH VOLTAGE 230V.
1. Before installing the light: Fold down the connector as shown in the Figure
1.
2. Place the bulbs in the sockets carefully in the direction of clockwise.
3. Once installed bulbs, fingers, unfold the rubber to its original position (Figu-
re 2) to seal the base of the bulb.
Nº LAMPHOLDERS
60
200
Tabla de contenido
