simplyput SP-BSC10-1-35-P Instrucciones De Instalación
  1. Manuales
  2. Marcas
  3. simplyput Manuales
  4. Cestas de Almacenaje
  5. SP-BSC10-1-35-P
  6. Instrucciones de instalación

simplyput SP-BSC10-1-35-P Instrucciones De Instalación

Ocultar thumbs
1
2
3
4
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Product Assemblies
SP-BSC10-1-35-P
Place sliding base assembly on cabinet floor,
1
in desired position. Position front mounting
strap against the back edge of the cabinet
face frame. (If installing in a frameless
cabinet, measure 1/2" to 3/4" back from
front of cabinet opening, and align sliding
base assembly parallel to cabinet opening.)
Close door to make sure the assembly will
not hold cabinet door open. Also, check to
see if unit will clear the door opening when
fully extended. Once position is determined,
fasten in place using four mounting screws
provided and a Phillips head screwdriver.
Optional Step: Mark placement of
mounting holes with a pencil, remove
sliding base assembly and drill pilot holes
for fastening screws. Place sliding base
assembly back into position and fasten
with the provided screws.
Single Pullout Waste Bin
Inspect all parts and read all instructions prior to beginning assembly and installation.
Tools Required
• Phillips Head Screwdriver
Parts Included
Waste Bin (1)
Wire Cage (1)
1
Installation Instructions
Optional
• Drill with 1/16" (1.5mm) bit for
drilling pilot holes
• Pencil
Sliding Base Assembly (1)
Clip-On Handle (1)
Mounting
Straps Sliding Members
Cage Locking Clip (1)
Mounting Screws
loading

Manuales relacionados para simplyput SP-BSC10-1-35-P

Resumen de contenidos para simplyput SP-BSC10-1-35-P

  • Página 1 Product Assemblies Wire Cage (1) Cage Locking Clip (1) Mounting Screws SP-BSC10-1-35-P Place sliding base assembly on cabinet floor, in desired position. Position front mounting strap against the back edge of the cabinet face frame. (If installing in a frameless cabinet, measure 1/2"...
  • Página 2 Fully extend sliding members out of the cabinet. Place the slotted holes on the cage onto the tabs on the left hand sliding member. (2A) Rest the cage on top of the clip retainers on the right hand sliding member, but, DO NOT PUSH DOWN.
  • Página 3 Soporte de alambre (1) Attache pour base (4) Vis de fixation (4) de productos SP-BSC10-1-35-P Colocar el conjunto de base deslizante en la posición deseada sobre el piso del gabinete. Poner la correa de montaje frontal contra el borde trasero del marco frontal del gabinete.
  • Página 4 Extender completamente los brazos deslizantes fuera del gabinete. Encajar los orificios del soporte en las pestañas del brazo deslizante de la izquierda. (2A) Colocar el soporte encima de los retenedores en el brazo deslizante de la derecha, pero sin presionar hacia abajo. Cerrar la unidad para que el soporte de alambre quede por completo dentro del gabinete.