West Elm box mirror shelf Instrucciones De Ensamblaje

NOTE :
• Maximum Load is 10lbs for drywall and 20lbs for stud
mount.
• The hardware included is meant for drywall or
stud mounting only.
• Designed to be used for decorative items only.
• Wipe with a soft, dry cloth. To protect the finish, avoid
the use of all chemicals and household cleaners.
MOUNT IN G PA TT ERN
0/2/0
étagère boîte avec miroir
le fait de monter des instructions
! For drywall mounting, use anchors with screws. For
stud mounting, use screws only.
1. This shelf comes with a paper mounting pattern which
can be used to locate the position of the shelf on your wall
and mark the insertion points of the mounting hardware.
The template outline indicates the line of the shelf edge
at the wall. The centerpoints are toward the top of the shelf
and indicate the point of insertion for the drywall anchors
and screws.
2. Temporarily tape the mounting pattern to the wall with
the outline indicating the desired location of the shelf.
3. Using a pin, poke through the mounting pattern into
the drywall at the center points to mark the locations
on the wall. Remove the mounting pattern.
4. For stud mounting, skip to step 5. For drywall mounting:
using a phillip's head screwdriver, insert the snapskru(a)
into the wall at the insertion points. Turn clockwise until
snapskrus are flush with the wall.
5. Insert screws(b) into the anchors or directly into studs at
the insertion points, leaving approximately 1/2" between
the back of the screw head and the wall.
6. Align keyhole notches on the back of the shelf over the
screw head and slide the shelf down until it rests on the
screws. Tighten or loosen screws as needed to fit the shelf
snugly against the wall.
box mirror shelf
caja repisa espejo
assembly instructions
instrucciones de montaje
a. snapskru 2x
b. screw 2x
Page  of 3