Domestic GROUP WAECO MagicTouch MT400 Instrucciones De Montaje Y De Uso página 30

Connecting MT400
7.2 Connecting MT400 to the central locking system
See fig. 6
➤ Connect MagicTouch in accordance with the corresponding circuit dia-
gram (for details, see table „Keys for the circuit diagrams" on page 28):
Vehicles without a servo motor in the driver's door (driver's door cannot
be locked and unlocked from the passenger's door) or with pressure vac-
uum central locking without electrical control cable: fig. 7
In these cases, you will require an additional servo motor, WAECO type
no. ML-11 for the driver's door.
Two cables switching from negative to +12 V: fig. 8
Two +12 V pulse control cables: fig. 9
Two negative pulse control cables: fig. 0
One open and negative pulse control cable: fig. a
One +12 V and negative pulse control cable: fig. b
Connection to the WAECO central locking system ML-44(22): fig. c
NOTE
I
Check whether the indicators flash once upon locking with the re-
mote control.
If they flash twice, you will need to reconnect the grey/yellow cable
to pin 12 and the blue/yellow cable to pin 13 of the control unit.
Keys for the circuit diagrams
No. in fig. 7
to fig. c
1
2
3
28
Designation
Control unit for the vehicle's own central locking system
Control switch (driver's door) for the original central locking
system, central locking closed
Control switch (driver's door) for the original central locking
system, central locking open
MagicTouch MT400