Battery Installation; Important - GPO CRS-132 Manual Del Usuario

Battery installation

1 To remove the battery compartment door (located on the cabinet
base) press the snap tab and lift the door off the rear of the cabinet.
2. Insert 4 "R14" (C CELL)-size batteries (not included) into the battery
compartment. Be sure the (+) or cap end of each battery is installed
as show on the battery diagram.
3. Replace the battery door.
NOTE: If the recorder begins to sound distorted, or the tape reels turn
very slowly or not at all, be sure to try a new set of batteries or another
cassette before seeking service.
IMPORTANT: Be sure to remove the batteries when storing the set for
more than a few weeks at a time. Leaking batteries can badly damage
the recorder. When discarding batteries, be sure to dispose of them in
the proper manner, according to national and regional regulations.
Always press STOP before storing. This will relieve pressure on certain
parts in the recorder that might deform after long periods of time.
6
1 2 3