Nexxt Solutions NHE-S100 Manual De Instrucciones página 7

Step 4
Mount the smart switch
- Using the correct polarity, match each wire from the smart
switch with those coming from the junction box.
- Connect the wire ends of each pair into the wire nut, then
twist each nut full turns until the connection is fully
secured. Repeat this step for each cable assembly.
Note: make sure that there is no wire exposed.
Make sure to follow the wiring con guration:
1) Neutral wire (white) on the smart switch to neutral on
junction box.
2) Ground wire (yellow/green) on the smart switch to
ground on junction box (ground wire maybe yellow/green
or bare copper wire) depending on existing electrical
installation.
3) Line/Live wire (black) on the smart switch to line /live
wire on junction box.
4) Load wire (red) on the smart switch to load wire on the
junction box.
For safety, properly ground the switch
Always follow the code standards when installing wired
connections.
Gently push all the excess wiring into the junction box.
Note: make sure all the wires are positioned in an
organized manner and away from the edges of the light
switch and the junction box, to avoid pinching any of the
cables, prior to completing the process.
Proceed to align the smart switch to the base on the
junction box, so that it is oriented correctly.
Insert the two center screws through the switch and into
the mounting hole on the junction box. Secure the switch
to the base of the box.
To complete installation, gently push the faceplate into the
box until it snaps in place.