Kobalt KXDD 1424A-03 Manual De Instrucciones página 13

OPERATING INSTRUCTIONS
10. Installing Bits
a. Remove the battery pack.
b. Open or close the chuck jaws to a point where
the opening is slightly larger than the shank of
the bit you intend to use.
c. Insert the bit.
d. Tighten the chuck jaws securely on the bit.
NOTICE: Rotate the chuck body in the direction of
the arrow marked GRIP to close the chuck jaws.
Do not use a wrench to tighten or loosen the chuck
jaws.
WARNING
• Make sure to insert the drill bit straight into the
chuck jaws. Do not insert the drill bit into the
chuck jaws at an angle and then tighten the
chuck, as shown in Fig. 11b. This could cause
the drill bit to be thrown from the drill/driver,
resulting in possibly serious personal injury or
damage to the chuck.
Removing Bits
a. Remove the battery pack.
b. Open the chuck jaws.
c. Remove the drill bit.
WARNING
• Do not hold the chuck body with one hand and
use the power of the drill/driver to tighten or
loosen the chuck jaws on the drill bit. The chuck body could slip in your hand, or your hand
could slip and come in contact with the rotating bit. This could cause an accident resulting in
serious personal injury.
11. Drilling
WARNING
• Always wear safety goggles or safety glasses
with side shields during power tool operation or
when blowing dust. If operation is dusty, also
wear a dust mask.
a. Check the direction-of-rotation selector (E) for
the correct setting (forward or reverse).
b. Secure the material to be drilled in a vise or
with clamps to keep it from turning as the drill
bit rotates.
c. Hold the drill/driver firmly and place the bit at
the point to be drilled. Hold with two hands if
need.
10a
10b
11
13