AVS Ventvisor Instrucciones De Instalación página 2

Front Visor Installation Steps Front Air Dam Installation Steps
Buff the outside rubber window channels where the visor will mount with a scotch brite pad, then clean
Be sure to prep all windows before installing the first visor to prevent surface prep pad from drying out.
3
Remove tape line from rear end flange. Expose 2" (5
cm) of tape from each end of top flange.
free end
top flange
rear
flange
4
Verify proper positioning, and gently press on exposed
areas of tape to secure in place.
6
Apply pressure along flange edges to ensure adhesion
and secure visor in place
8
NOTE: Actual application may vary slightly from illustrations.
with an alcohol pad.
NOTE: See surface prep warning on page 1
free end
front
flange
Page 2 of 3
Align the visor with the previously prepared window
surface. The front flange slides under the loosened
mirror cap.
front flange under
mirror cap
mirror cap
5
With the visor in its final position, remove remaining
tape liner by pulling on free ends.
7
Retighten loosened nut and reinstall interior mirror cap.
9
Repeat Steps 1 - 9 for passenger side.