KALLISTA P50035 Manual Del Usuario página 9

Troubleshooting Procedures (cont.)
Troubleshooting the Whirlpool System
Symptoms
2. Motor starts, but all jets are not
functioning.
3. User keypad is illuminated but
does not respond to buttons.
4. User keypad indicator bar
keeps scanning at power-up.
5. User keypad is illuminated, but
pump won't start.
6. Motor runs but pump won't
prime (cavitates).
7. Pump stops before 18 minutes.
Kallista
Probable Causes
C. Wiring harness from user
keypad to control is loose,
disconnected or damaged.
D. Keypad doesn't work.
E. Control doesn't work.
A. Jet is closed.
B. Jet not installed correctly.
C. Jets are blocked.
A. Control program is locked.
B. Wiring harness from user
keypad to control is loose,
disconnected or damaged.
C. Keypad doesn't work.
D. Control doesn't work.
A. Control program is locked.
B. Wiring harness from user
keypad to control is loose,
disconnected or damaged.
C. Keypad doesn't work.
D. Control doesn't work.
A. Power cord from pump to
control is loose, disconnected
or damaged.
B. Pump doesn't work.
C. Control doesn't work.
A. Pump is shimmed too high.
B. Small air leak at pump inlet.
C. Motor/pump doesn't work.
D. Control doesn't work.
A. GFCI or ELCB tripped.
B. Suction is blocked.
C. Jets are blocked.
9
Recommended Action
C. Check wiring for proper
connections Replace wiring
harness if necessary. Refer to
installer/dealer.
D. Replace user keypad. Refer to
installer/dealer.
E. Replace control. Refer to
installer/dealer.
A. Rotate jet trim ring
counterclockwise to open.
B. Reinstall jet; check for O-ring
damage.
C. Remove blockage.
A. Reset GFCI or ELCB.
B. Check wiring for proper
connections. Replace wiring
harness if necessary. Refer to
installer/dealer.
C. Replace user keypad. Refer to
installer/dealer.
D. Replace control. Refer to
installer/dealer.
A. Reset GFCI or ELCB.
B. Check wiring for proper
connections. Replace wiring
harness if necessary. Refer to
installer/dealer.
C. Replace user keypad. Refer to
installer/dealer.
D. Replace control. Refer to
installer/dealer.
A. Check wiring for proper
connections. If problem
persists, refer to
installer/dealer.
B. Replace pump. Refer to
installer/dealer.
C. Replace control. Refer to
installer/dealer.
A. Lower pump/control to
subfloor level.
B. Securely tighten nuts(s) on
intake side of pump.
C. Replace motor/pump. Refer to
installer/dealer.
D. Replace control. Refer to
installer/dealer.
A. Identify source of fault, and
correct. Reset GFCI or ELCB.
B. Remove obstruction.
C. Remove blockage.
1019455-5-B