Safety Information - K-Tool KTI-63094 Manual De Usuarios

The K-Tool 1.5 Ton Aluminum Double-Piston Hydraulic Floor Jack raises the vehicle quickly, and
with a 3-5/8" minimum saddle height, it gets under low-profile vehicles without a problem. It's
made of strong, lightweight, aluminum for easy maneuvering around your garage. Meets ANSI
specifications and ASME PASE/2014 Safety Standards.

SAFETY INFORMATION

READ INSTRUCTIONS!
• Read this entire manual before set up and use.
• Keep this manual in a safe location as it will be necessary to refer to it often.
SAFETY WARNINGS
• Always wear ANSI-rated eye and hand protection when using this jack.
• Keep children away from work area.
• Pinch Hazard. Keep hands and feet away from moving parts when operating.
• Do not exceed the load rating of the jack (1.5 Ton/3300 lbs.)
• This jack is for lifting purposes only! Use proper jack stands for sustaining
• Only use this jack on level, flat, hard surfaces.
• Purge air from the hydraulic pump prior to first use and any time necessary
• The operator and any bystanders of the jack should be trained and use care
• Improperly secured loads, overloading, and off-center loads may all lead
• Do not use this jack for a task it was not designed for.
• Before each use the operator should inspect the jack for any abnormal
• Do not move the vehicle or other load while on the jack.
• Lift vehicles only in areas that are specified by the manufacturer of the vehicle.
INITIAL SET UP
INSTALLING HANDLE
1. Attach the upper(#44) and lower(#42) handle together by aligning the ball detent.
2. Loosen the thumb screw(#40) on the floor jack where the handle is installed. Slide the
handle into the socket while lining up the square drive on the jack to the handle.
3. Tighten the thumb screw(#40) to secure the handle in its place.
any load. Before going under any lifted object, support the load with stands
suitable for the weight.
during the life of the jack.
while operating.
to failing, slipping, falling, etc. of the object being supported. It is up to the
operator to properly load the jack.
conditions including broken, damaged or missing parts as well as leaks.
2
Nov 2016