Before Installation; Installation Steps - Pulse New Gate Instrucciones

ING
MICRAC PULSE

BEFORE INSTALLATION

Ensure you have a router with an external public IP. A public IP is one that is NOT in any of these ranges:
10.0.0.0 – 10.255.255.255
A
172.16.0.0 – 172.31.255.255
192.168.0.0 – 192.168.255.255
B Ensure you have an available internal IP in your network.
Enable a forwarded port in your router with the following parameters:
* IP: The choosen internal IP.
C * External port: An available external port.
* Internal port: 80.
Check the user manual of your router for more information about port forwarding.
Before continuing, ensure you have a Cloudfort system user. If you don't have one, visit the Cloudfort website at
D
http://cloudfort.life and follow the registration instructions, using your email address.

INSTALLATION STEPS

Remove the rubbet feet, remove the screws and remove the cover. Make the necessary connections of the Micrac Pulse acoording to
1
the following connection diagram.
• +V: Power (positive) +5 V to +24 V.
• -V: Power (common).
• Signal + and Signal - : They must be
wired to the external pushbutton
connection, regardless of the polarity.
• Sensor and GND : connect both
wires of the provided cycle sensor,
no matter the polarity.
Once the power is connected, look for a WiFi network called "ESPXXXXX" from your mobile phone or your computer. If the network
2
doesn't show up it's because it's already configured. If that's the case, to delete the data already stores press at least once the clear button and the
reset button.
3
Connect to the Micrac Pulse's wifi network with your mobile phone or computer.
+V
-V
External
pushbutton
connection
Alternative
GND
Sensor
pushbutton