Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

H-99
INDUSTRIAL AUTOMATIC
TAPE DISPENSER
Do not leave the tape
dispenser in direct sunlight.
Do not use the tape dispenser
in humid or dusty places.
• If using automatic feed, when one piece of tape is
removed, the unit will automatically feed and cut
the next piece at the preset length.
• The tape length is easily seen on the LED display,
and operation is simple. Press the CM key or MM key
to set the length. (Setting limit 20mm to 999mm.)
PAGE 1 OF 15
1-800-295-5510
uline.com
NOTES
Do not drop the tape
dispenser or subject it to
heavy shocks.
Do not insert bars or plates
into the tape outlet-this will
damage the blades.
FEATURES
• If a piece of long tape is needed, press the
ADVANCE key for desired length, then press CUT key
to cut.
• The blade unit can be removed and replaced easily.
(Tape jamming is also easily fixed by removing the
blade unit.)
Para Español, vea páginas 6-10.
Pour le français, consulter les pages 11-15.
Do not use volatile liquids
(benzine, thinner, etc.)
to clean the dispenser.
Wipe with dry cloth only.
DO NOT insert your fingers
into the tape outlet!
0621 IH-99
Tabla de contenido
loading

Resumen de contenidos para Uline H-99

  • Página 6: Despachador Automático De Cinta Adhesiva Industrial

    H-99 800-295-5510 uline.mx DESPACHADOR AUTOMÁTICO DE CINTA ADHESIVA INDUSTRIAL NOTAS No deje el despachador No deje caer el No utilice líquidos volátiles de cinta adhesiva expuesto despachador de cinta (bencina, diluyente, etc.) para directamente al sol. adhesiva ni lo someta a limpiar el despachador.
  • Página 7: Partes Y Funciones

    PARTES Y FUNCIONES Carrete Pantalla de Largo de la Cinta Adhesiva Perilla de Presión Teclas de Ajuste del Largo Tecla de Reinicio Tecla de Reversa Tecla de Corte Tecla de Avance Tecla de Avance/Corte Interruptor del Sensor Enchufe del Sensor Fusible Rodillo de Rodillo...
  • Página 8: Funcionamiento

    FUNCIONAMIENTO USAR EL DESPACHADO AUTOMÁTICO PARA REEMPLAZAR LA UNIDAD DE LA CORTADORA Enchufe el cable de electricidad y encienda la unidad. 1. Apague el sensor y la electricidad antes de quitar la unidad de la cortadora. Desconecte el enchufe 2. Coloque la cinta adhesiva en el centro del carrete del sensor y a continuación estire de la unidad de y pegue el extremo de la cinta adhesiva al rodillo la cortadora hacia adelante a la vez que presiona...
  • Página 9: Continuación De Funcionamiento

    CONTINUACIÓN DE FUNCIONAMIENTO CONFIGURAR LAS MEMORIAS 4. Una vez fijados los largos, en la pantalla parpadeará un "0". Presione la tecla MM para Presione y mantenga presionada la tecla M hasta alternar entre "0" y "5". que la pantalla LED parpadee. •...
  • Página 10: Solución De Problemas

    Ponga una gota de aceite de silicón en cada forro o reemplácelos según sea necesario. Inspeccione el rodillo de alimentación y la navaja en busca de fragmentos de cinta adhesiva o acumulación de adhesivo. Límpielo con alcohol. 800-295-5510 PAGE 10 OF 15 0621 IH-99 uline.mx...

Tabla de contenido