Rear Panel - Sonia Poli Micro Manual Del Usuario

Microdermoabrasion
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

REAR PANEL

2
1
1
Connecting the suction hose
2
Electrical power supply connector
3
Fuse
CONNECTION AND ASSEMBLY
INSTRUCTIONS
● First of all, remove two screws from the bottom of
the main body. A sticker on the device indicates the
need to remove them and highlights the two screws
in question.
● Connect the power cable to the rear panel of the
main body. A blue LED will automatically light up
around the main unit and the display screen and
parameter control will be activated.
● Choose one of the diamond-tipped heads and
connect it to the handpiece using the thread. Put
the cotton filter inside the head first.
● Connect the suction hose to the corresponding
outlet on the rear panel and on the end of the
handpiece, as indicated in the picture. Note the
direction of the arrow on the intermediate filter. It
should be pointing towards the handpiece.
POWER AND CONFIGURATION
● After connecting the power supply cable and the
blue LED has lit up around the main unit, the
language selection menu will be activated on
the display screen: select the desired language
(Spanish or English).
● Press [POWER] on the control panel to turn off the
device. The selected language will be memorised.
● Press the [POWER] button on the control panel. On
the display screen and parameter control:
- The timer will show 15 minutes.
4
- The power indicator will show 5.
- The pause indicator
● Set the timer using the
the operating time of the machine, in a range of
between 1 and 30 minutes.
● Set the power using the
the power of the machine, in a range of between 1
3
and 9.
● Use the
to start or stop the device.
- When in operation, an animation will be shown on
- When it is paused or on standby, the animation
● To change the previously memorised language when
starting the device for the first time, disconnect
the power cable and wait for 10 seconds. After
reconnecting, the language selection menu will
appear again.
OPERATION
● Connect the device and leave it in standby mode
with the
● Set the power to the minimum and select the
operating time.
● Hold the handpiece with your hand and press
or press on the display screen. An animation will
automatically be shown on the display screen and
the device will start up.
● Place the device on the skin of the area to be
treated to start the treatment, adjusting the suction
power according to your needs.
Bear in mind:
● Clean the skin before starting the treatment.
● Make sure you have placed the cotton filter inside
the selected head beforehand.
● To switch the heads or one handpiece for another,
put the device in standby mode.
● The vacuum power should be kept under control, as
a high power could cause skin lesions.
● Test first on your own hand, and then start with the
patient once the vacuum power has been set.
● Regularly replace the cotton filter with a new one.
● The higher the number on the diamond-tipped
head, the finer the grain. Keep this in mind
according to the treatment to be performed.
● In addition to the grain, there are heads of different
sizes. Select the appropriate measurement
according to the area to be treated.
will appear on the display
screen.
or
button or press on the display screen
the display screen.
will stop and the
indicator will appear on the
display screen.
indicator lit.
buttons to choose
or
buttons to choose
Tabla de contenido
loading

Este manual también es adecuado para:

H3208

Tabla de contenido