CLEANING & MAINTENANCE
If Sprayhead and Seal are separated during removal or cleaning, they must be reassembled
properly for My Café
Identify the top of the Seal – it will have
1.
rough ridges while the bottom is smooth
Identify the top of the Sprayhead – it has
2.
a star pattern and a threaded hole where
the Sprayhead attaches to the Coffee
Maker.
Guide the Sprayhead into the channel of
3.
the Seal. Gently stretch the Seal if needed.
Make sure it is completely in the channel.
There are two stainless steel Water Probes in the Pour-In Bowl that are designed to detect if
water is present. Minerals from the water you use may build up in the Pour-In Bowl and on the
probes and may cause the Coffee Maker to incorrectly read that water is in the Pour-In Bowl.
1.
2.
3.
Unplug the Coffee Maker and wait for it to cool. It must be stored above 40°F/4°C to prevent
damage to the internal Hot Water Tank. If you do not use your Coffee Maker for an extended
period of time, we recommend running two to three cycles of water through prior to brewing
coffee or tea.
NOTE: After Initial Set Up, water will remain in the internal Hot Water Tank.
reassembling the sprayhead
Coffee Maker to function.
®
CORRECT
cleaning water probes
Unplug the Coffee
Maker and allow it to
cool (minimum 1 hour).
Then rotate the Spin
Lid open.
Remove the 2 screws
in the Pour-In Bowl
with a Phillips head
screw driver.
Remove top of the
Pour-In Bowl by lifting
the front edge up
slightly, sliding the lid
back to unhook it and
then lift off.
storing the coffee maker
(Seal visible and
(Seal partially obstructed
not obstructed)
When properly assembled, the Sprayhead
will slide easily into the channel of the
Seal and will not cause any buckles in the
surface of the Seal.
11
/
seal
INCORRECT
by Sprayhead)
CAUTION: Improper reassembly
could result in personal injury from
hot water.
Gently scrub the Water
4.
Probes and surrounding
area with a textured
sponge or a toothbrush
to remove deposits.
Replace top of Pour-In
5.
Bowl by sliding forward
until rear catch engages,
then lower the front of
the lid.
Re-install the screws
6.
to the Pour-In Bowl
lid. Perform Coffee
Maker Maintenance as
directed on page 10.
INCORRECT
(Seal behind Sprayhead)