Idiomas disponibles
Idiomas disponibles
Install screws through holes in
Install screws through holes in
cabinet as shown in Fig. 1
cabinet as shown in Fig. 1
DO NOT OVERTIGHTEN!
DO NOT OVERTIGHTEN!
Use SS328 #8 x 1 1/2 Phillips head.
Top View
Cabinet flange fits
flush against wall.
2. Surface Mounting the Cabinet on the Wall.
A. Install Mounting Bar
1. Drill two 3/16" holes in bottom mounting bar at indent location.
Use supplied anchors or locate studs if possible.
Fig. 2
3/4"
2. Drill 3/16" hole in wall for mounting bar anchors at locations
shown in Fig. 2. ( If you do not use the anchor, drill a 3/32"
pilot hole.) After the holes are drilled, fit the mounting bar
onto the wall, refer to Fig. 2 for measurements, and Fig. 4 for
information on anchor cinching.
B. Install Top Clips
(Left and right top clips come connected, hold both clips and
snap them apart).
1. Fit cabinet into position on mounting bar as shown in Fig. 3A.
2. Place clip in position as shown in Fig. 3B and mark with a
pencil. Remove clip and cabinet and drill the pilot or anchor
holes where marked.
3. Fix both the clips into position with a screw, and slide the clip
into the up position. Sit the cabinet on the mounting bar, then
lower and tighten the screws into place, as shown in Fig 3B.
4. See Fig. 4 for proper turns required for anchor cinching.
5. See page 3 for side kit application.
INSTALLER'S NOTE:
Installing the cabinet on a wall without the door attached can
make installing easier for one person. Do not mount the doors
until the box is in or on the wall.
209-1019 Devonshire Cabinet
Fig. 1
Stud and wall
surface
Install dome caps
over screws.
4 1/2" from edge of
cabinet.
Bottom of Cabinet
Fig. 3A
Cabinet bottom sits
in lip on bottom
mounting bar
11" bottom mounting bar
Fig. 3B
#8 x 2" Hex head screw
(Use 1/4" driver)
Once Screw is bottomed out on
mount clip, turn screw an additional
5 to 7 turns to fully expand the anchor.
Side view at top of cabinet
#8 x 2" Hex
head screw &
Wall anchor
(use 1/4" driver)
Wall anchor
(if required)
Top mount clip
Fig. 4
