Base Set Up; Changing The Rubber Ear Buds; Installing Batteries In The Remote Control; Registering The Handset - Amplicomms TV3500 Manual De Instrucciones

Base set up

Charge the headset for about 2 hours and 30 minutes before first use. Place the
headset on the charging cradle of the base. The headset LED indicator will be
red and will turn to purple when the battery is fully charged.
• A fully charged battery provides up to 6 hours of listening enjoyment.
Advice: Always have the headset fully charged and operational, put the headset
back on its charging base after use.

Changing the rubber ear buds

1. For optimum user experience, we have provided 2 sizes of ear buds. Large
and Small. If the small size fitted to the headset does not suit you, please try
the alternative large size ear bud supplied in the box.
2. For changing the ear buds pick the mounted ear buds at the end and gently
pull them out. Then position the alternative ear buds onto the "open ends"
and let them snap into the place.

Installing batteries in the remote control

1. Insert AAA size batteries into the remote control with correct polarity.
2. To test the functions, put the headset on your ears and turn on the TV. Point
the remote control to the base and press the volume
or balance buttons or
Registering the headset
The base and the headset are paired in advance. Normally, there is no need to
pair them again.
1. Press and hold the Pair button at the back of the base for 10 seconds. The
power LED will flash continuously.
2. Press and hold the
flash continuously.
3. When registration is successful, the base and the headset LED will become
steady on.
button to adjust the sound level and quality.
button on the headset for 10 seconds. The LED will
21
or buttons,