Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7. Wrap the section around the rounded brush
beginning with the end of the section.
8. Leave the section wrapped around the
rounded brush until it feels warm.
9. Carefully unwrap the section. Do not pull on
the section as this may destroy the styling
effect.
10. Repeat steps 6 to 9 to style the remaining
strands.
alumInIum curlIng bruSh
The curling brush is ideal to style short to medium short hair and to give more volume.
1. Prepare your hair as described in the chapter
„Before first use".
2. Attach the curling brush to the appliance.
3. Connect the plug to a wall socket.
4. Switch the appliance on using the „EIN/
AUS" [ON/OFF] switch.
5. Heat the appliance up for a couple of
minutes in order to achieve the best styling
result.
6. Separate the combed hair into strands no
more than 5 cm wide. If necessary, separate
the strands using hair clips.
7. Wrap the section around the rounded brush
beginning with the end of the section.
haIr StraIghtener/haIr crImper
The plates of this attachment have a flat and a ridged side each. According to the effect you want
to achieve, just pull the plates off the attachment, turn them and reattach them until they latch into
place.
The plates of the hair straightener have a ceramic coating, which protects your hair. Nevertheless
you should not straighten your hair too often. This applies especially to colour treated or otherwise
chemically treated hair (e.g. perms).
Before straightening your hair please do not use any chemical hair-styling products like hair spray to
avoid burning your hair.
Using the hair straightener (flat side of the plates) allows you to gently straighten your hair.
The hair crimper (ridged side of the plates) gives your hair little waves.
1. Prepare your hair as described in the chapter
„Before first use".
2. Attention: your hair should be completely
dry before straightening. Straightening your
hair when it is still damp will damage your
hair. Therefore you should dry your hair well
using a hair dryer, if necessary.
3. Attach the accessory to the appliance.
Check if the plate is inserted with the
desired side up.
4. Connect the plug to a wall socket.
11. Always switch the appliance off using
the EIN/AUS [ON/OFF] switch before
disconnecting the plug from the wall socket.
Please remember that the accessories and
the appliance are very hot after use. Change
the accessories only after an adequate cool-
off time in order to avoid burns.
8. Leave the section wrapped around the
rounded brush until it feels warm.
9. Carefully unwrap the section. Do not pull on
the section as this may destroy the styling
effect.
10. Repeat steps 6 to 9 to style the remaining
strands.
11. Always switch the appliance off using
the EIN/AUS [ON/OFF] switch before
disconnecting the plug from the wall socket.
Please remember that the attachments are
very hot after use. Change the accessories
only after an adequate cool-off time in order
to avoid burns.
hair straightener:
5. Separate the combed hair into strands no
more than 5 cm wide. If necessary, separate
the strands using hair clips.
6. Switch the appliance on using the „EIN/
AUS" [ON/OFF] switch.
7. Heat the appliance up for a couple of
minutes in order to achieve the best styling
result.
8. Open the appliance and place a small
section of hair between the straightening
plates close to the root.
15
Tabla de contenido
