15. Caution (if applicable): Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type. Batteries (a battery pack or an
installed battery) shall not be exposes to excessive heat such as sunshine, fire,
etc.
16. (If applicable) Where the mains plug or an appliance coupler is used as the
disconnect device, the disconnect device shall remain readily operable.
17. Protective earthing terminal (if applicable): The apparatus should be
connected to a mains socket outlet with a protective earthing connection.
• Denmark (Danmark): Apparatets stikprop skal tilsluttes en stikkontakt
med jord, som giver forbindelse til stikproppens jord.
• Finland (Suomi): Laite on liitettävä suojakoskettimilla varustettuun pistorasiaan.
• Norway (Norge): Apparatet må tilkoples jordet stikkontakt.
• Sweden (Sverige): Apparaten skall anslutas till jordat uttag.
18. (If applicable) This symbol means the equipment is a Class II or double-
insulated electrical appliance. It has been designed in such a way that it
does not require a safety connection to electrical earth.
19. Warning (if applicable): Provide an earthing connection before the mains plug
is connected to the mains. When disconnecting the earthing connection, be
sure to disconnect it after pulling the mains plug out from the mains.
20. This apparatus is for professional use only. Intended operational climate:
tropical, moderate.
21. (If applicable) When moving or not using the appliance, secure the power cord
(e.g., wrap it with a cable tie). Be careful not to damage the power cord.
Before using it again, make sure the power cord has not been damaged. If the
power cord has been damaged at all, bring the unit and cord to a qualified
service technician for repair or replacement as specified by the manufacturer.
22. Warning (if applicable): Excessive sound pressure (high volumes) from
headphones can cause hearing loss.
23. Warning (if applicable): Please refer to any important information (e.g.,
electrical, safety, etc.) printed on the exterior bottom enclosure or rear panel
before installing or operating the product.
Service Instructions
• Disconnect power cord before servicing.
• Replace critical components
equivalents.
• For AC line powered units: Before returning repaired unit to user, use an
ohmmeter to measure from both AC plug blades to all exposed metal parts.
The resistance should be more than 2,000,000 ohms.
only with factory parts or recommended
11