Idiomas disponibles
Idiomas disponibles
DIP SWITCHES
When set to Off, it allows line-level
signal input through channel 1. When
CH1 MicOn/LineOff
set to On, it allows microphone-level
signals through channel 1.
This switch sets channel 1 to normal,
CH1 Normal
with no priorities.
Enables muting of channels when
priority circuit on input 1 is closed.
Connect the priority connection on
CH1 Priority
Input 1 to microphone's push-to-talk
function when this is activated.
Activating this switch allows automatic
muting when channel 1 input passes
CH1 VOX
the preset threshold.
Activating
channel 1 input signal to the zone 2
CH1 to Zone 2
output channel.
Activating
channel 2 input signal to the zone 2
CH2 to Zone 2
output.
Activating this switch will reduce the
input signal level of channel 2 by 28 dB
CH2 PAD
making it ideal for low-impedance
devices.
This switch activates phantom power to
the Input 1 input. Phantom power is
Phantom Power
required
microphones.
INPUT WIRING
Phonic recommends that customers use pre-built balanced line
connectors with 22 to 24 gauge cable. Unbalanced connections
could also be used however are susceptible to noise.
Priority Muting
Phonic'
GA6120
and
GA6240
mixer/amplifiers allow users to mute
background signals in favour of the
microphone/line input 1 signal. To
use
a
microphone's
push-to-talk
switch, first connect the mic's push-to-
talk contact switch to the priority
connector
of
the
Mic/Line
Ensure the CH1 Normal DIP switch
is set to OFF and the CH1 Priority
DIP switch is set to ON. This enables
users to mute all other signals when
the microphone's push-to-talk button
is engaged.
this
switch
sends
this
switch
sends
for
use
with
condenser
input.
http://www.phonic.com
GA6120 / GA6240 EASY MANUAL
OUTPUT WIRING
Speakers
Output to speakers can be achieved by slipping cable lugs
underneath the output screw terminals. Tighten screws to fasten in
place. Customers may choose to use crimp-on spade lugs.
Phonic recommends that customers use professionally wired high
gauge cables. The plastic cover can be slid into place to protect
connections. It is recommended that you insulate exposed wires to help
prevent against the possibility of short-circuits. Class 2 wiring is
required.
The GA6120 offers 120 Watts of power while the GA6240 offers
240 Watts (whether using 8 ohm or direct voltage 70V/100V output).
Zone 2 / MOH
the
External music sources can be sent over
phone lines while a caller is on hold using
the
the Phonic GA series. Connections can be
completed
as
indicated
either the 8 ohm or 600 ohm connections.
Connect
the
Zone
telephone system or PBX's music-on-hold
input.
WARNING:
Do not use shielded cable
for
output
power
recommends use of 2-conductor shielded cable
and 3-pin Phoenix-type connectors for Preamp
t.
Line outpu
below
using
2/MOH
to
your
wiring.
Phonic
To telephone system
interface/PBX input
