Final Checklist - Verona VEBIEM3024NSS Instrucciones De Installación

EN
Important: Use twist-on connector
with square-wire spring
Square-wire springa

Final Checklist

To prevent improper connections leading to damage of
electrical components and so voiding the warranty, the
following steps must be performed:
1. Check the electrical requirements and make sure you have
the correct electrical supply and that the oven is properly
grounded.
2. Turn on the power supply to the oven.
3. Check power at the junction box wires using a voltmeter
having a range of 0-250V.
If you have installed the oven for use on 240V supply, you
should nd that the voltage reading between the black and
red wires (Line to Line) should be 220V to 240V.
If you have modied the oven(s) for use on 208V, the
voltage reading between the black and red wires should
be 190 to 208V.
4. Set the clock by following these steps:
• Immediately turn [+/-] knob to set hours + [INC] or - [DEC].
• Press [+/-] knob again to change minutes.
• Immediately turn [+/-] knob to set minutes + [INC] or -
[DEC].
• Press [+/-] knob or wait for a few seconds to confirm.
Clock is now set.
5. Test the bake mode by following this step:
• Move cooking mode knob to "BAKE" position. • Cooling fan and oven lights will turn on, the preheat led
will start to blink.
• A beep is sounded when the oven reaches the preset 350
°F (175 °C) and the preheat light stop to blink.
• Move the knob back to "OFF" position to stop cooking.
6. To check the other oven functions refer to the "Using the
Oven Controls" section of the USER MANUAL.
7. If the oven is working properly, turn o the power supply to
the oven.
8. Place the cover on the junction box and make sure the
cover is securely fastened and turn on the power to the
oven.
Leave these INSTALLATION instructions as well as the
Operating Instructions with the owner.
8
From power
supply
Or
From the oven