Installing The Pluto Safety Seat - Be Cool pluto Manual Del Usuario

EN
1. INSTALLING THE SAFETY SEAT
Installation from 9 kg up to 18 kg (76-105cm):
1a. Slide the Isofix anchors (11) to their maximum
length by turning the lever (13). Do this on both sides
of the seat.
1b. Open the cover (4) and take the top tether
connector out (14).
1c. Connect the Isofix anchors until you hear them
click into place. The display window on the button (12)
will turn from red to green.
1d. Push the seat as far back as possible. Make sure
that both Isofix are in the same position once you
have pushed the seat back.
Connect the Top Tether in the anchor point inten-
1e.
ded for this in the vehicle marked with the symbol:
30
1f. Lastly, tighten the strap of the TT system until the
green signal is displayed on the indicator. The strap
should go over the backrest of the vehicle seat. If
necessary raise the headrest or remove it to enable
correct installation.
The ISOFIX visual indicators show whether the
connector is open or do sed. The connector may be
closed without being secured in the ISOFIX anchor.
Please make sure that the connectors are correctly
fastened into the anchor points of the vehicle by
pulling the seat once it has been installed.
To detach the seat follow the same steps in reverse:
Move the button (12) to open the connector and
1g.
release the anchors.
Installation from 15 kg up to 36 kg (105-135cm):
Follow the same steps as before, 1a, 1b, 1c, and 1d. In
this case you should not connect the Top Tether.